Error Messages
While Audyssey 2EQ® Room Correction and Speaker Setup is in progress, one of the error messages below may appear.
2EQ: Auto Setup
AUDYSSEY
Ambient noise is too high. Error message
Retry
Cancel
The options are:
`Retry:
Try again.
`Cancel:
Cancel Audyssey 2EQ Room Correction and Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from that of the first measurement. Check the speaker connection.
• Writing Error!
This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. “No” means that no speaker was detected.
Tip
•See “Speaker Configuration” for appropriate settings (➔ page 13).
Changing the Speaker Setup Manually
You can manually make changes to the settings found during Audyssey 2EQ Room Correction and Speaker Setup.
See also:
•“Speaker Configuration” (➔ page 43)
•“Speaker Distance” (➔ page 44)
•“Level Calibration” (➔ page 44)
Using a Powered Subwoofer
If you’re using a powered subwoofer and it outputs very
If the “Subwoofer” appears on the “Review Speaker Configuration” screen as “No”, increase the subwoofer’s volume to the
En
31