3 When you’ve finished making the settings, press
ENTER.
2EQ: Auto Setup
| AUDYSSEY |
Speakers Type (Front) | Normal |
Powered Zone2 | No |
Surround Back/Front High | Surround Back |
Perform the “Speaker Setup” according to your speaker configuration:
–Speakers Type (Front) (➔ page 43)
–Powered Zone 2 (➔ page 43)
–Surround Back/Front High (➔ page 43)
When an optional unit is connected to the UNIVERSAL PORT jack on the AV receiver, the optional unit setting may appear on the speaker setting menu.
4 Use q/wto select “Audyssey Quick Start” or “Audyssey 2EQ Full Calibration”.
5 Press ENTER.
Audyssey 2EQ® Room Correction and Speaker Setup starts.
Test tones are played through each speaker as Audyssey 2EQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone. Do not disconnect the speaker setup microphone during Audyssey 2EQ Room Correction and Speaker Setup, unless you want to cancel the setup.
If you select “Audyssey Quick Start”, you will go to step 8.
6 | Place the setup microphone at the next position, |
| and then press ENTER. |
| Audyssey 2EQ performs more measurements. This |
| takes a few minutes. |
7 | When prompted, repeat step 6. |
8 | Use q/wto select an option, and then press |
| ENTER. |
2EQ: Auto Setup |
|
|
|
| AUDYSSEY |
Subwoofer | : | Yes |
Front | : | Full Band |
Center | : | 40Hz |
Surround | : | 100Hz |
Front High | : | None |
Surround Back | : | 120Hz |
Surround Back Ch | : | 2ch |
Save |
|
|
Cancel |
|
|
The options are:
`Save:
Save the calculated settings and exit
Audyssey 2EQ Room Correction and Speaker
Setup.
`Cancel:
Cancel Audyssey 2EQ Room Correction and
Speaker Setup.
Note
•You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by
En | using e/r. |
9 Use q/wto select a target, and use e/rto change the setting.
After the results of Audyssey 2EQ have been saved, the menu will display the “Audyssey” (➔ page 46), “Dynamic EQ” (➔ page 46), “Dynamic Volume” (➔ page 47) settings.
Note
•When “Audyssey Quick Start” has been used for measurement, “Audyssey” cannot be selected.
•These settings are applied to all input selectors.
10 Press ENTER.
11 Disconnect the speaker setup microphone.
Note
•You can cancel Audyssey 2EQ Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.
•Do not connect or disconnect any speakers during Audyssey 2EQ Room Correction and Speaker Setup.
•If the AV receiver is muted, it will be unmuted automatically when Audyssey 2EQ Room Correction and Speaker Setup starts.
•Changes to the room after Audyssey 2EQ Room Correction and Speaker Setup requires you run Audyssey 2EQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed.
30
