Audio Adjust
Main menu | Audio Adjust |
With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.
Multiplex/Mono
■Multiplex Input Channel
`Main
`Sub
`Main/Sub
This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.
■Mono
Input Channel
`Left + Right
`Left
`Right
This setting specifies the channel to be used for playing any
Dolby
■PL IIx Music (2ch Input)
These settings apply to only
Panorama
`On
`Off
With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music listening mode.
Dimension
`
With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic IIx Music listening mode. Higher settings move the sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move it backward.
Center Width
`0 to 3 to 7
With this setting, you can adjust the width of the sound from the center speaker when using the Dolby Pro Logic IIx Music listening mode. Normally, if you’re using a center speaker, the center channel sound is output from only the center speaker. (If you’re not using a center speaker, the center channel sound will be distributed to the front left and right speakers to create a phantom center). This setting controls the front left, right, and center mix, allowing you to adjust the weight of the center channel sound.
■PL IIz Height Gain
`Low
`Mid
`High
The Height Gain Control in Dolby Pro Logic IIz enables the listener to select how much gain is applied to the front high speakers. There are three settings, “Low”, “Mid” and “High”, and the front high speakers are accentuated in that order. While “Mid” is the default listening setting, the listener may adjust the Height Gain Control to their personal preference.
Note
•If the “Front High” settings is set to “None” (➔ page 43), this setting cannot be selected.
■Dolby EX Dolby EX
`Auto:
If the source signal contains a Dolby EX flag, the Dolby EX listening mode is used.
`Manual:
You can select any available listening mode.
This setting determines how Dolby EX encoded signals are handled. This setting is unavailable if no surround back speakers are connected. This setting is effective with Dolby Digital, Dolby Digital Plus and Dolby TrueHD only.
Note
•If the “Surround Back” setting is set to “None” (➔ page 43), this setting cannot be selected.
•If the “Front High” setting is enabled (➔ page 43), this setting is fixed at “Manual”.
En
45
