Use and Care of Ventilating Hood Models JV322J, JV324J, JV332J, JV334J, JV334R, JV335R, JV624J, JV634J, JV634R & JV635R
READ AND SAW THESE INSTRUCTIONS
Important Safety Instructions
When you get your new hood...
●Have it installed and properiy grounded by a qualified technician in accordance with the installation instructions.
●Have installer show you the location of the hood circuit breaker or fuse and mark it for easy reference.
●Take the time to read our suggestions for best use.
When using your hood...
●Due to the hood fan drawing power, special caution is needed to avoid spreading of possible flame from the cooking surface of your range.
●Never leave surface units unattended at high heat settings. Boilover causes smoking and greasy spillovers that may ignite and spread if hood is used. Use surface unit heat settings recommended by manufacturer and
●When flaming foods are under the hood, turn the fan off. The fan, if operating, may spread the flame.
●Never use your cooking appliance for warming, or heating the room. The electrical wiring of your range hood may not withstand the resulting excessive heat.
●Keep hood and grease filters clean according to instructions to maintain good venting and to avoid grease fires.
☛DO NOT USE WATER ON GREASE FIRES. NEVER PICK UP A FLAMING PAN. Smother flaming pan with well fitting lid, cookie sheet or flat tray, and, IF YOU CAN DO SO WITHOUT GETTING BURNED, immediately turn “OFF” the surface unit switch and hood. If there is danger of being burned, wait until AFTER flame has been reduced.
Flaming grease outside pan can be extinguished by baking soda, or, if available, a
If you need service...
●Do not attempt to repair or replace any part of your hood unless it is specifically recommended in this book. All other servicing should be referred to a qualified technician.
. Disconnect hood circuit breaker or fuse before performing any service.
Write down the model and serial numbers.
You’ll find them on a label on the back wall of the hood. These numbers are also on the Consumer Product Ownership Registration Card that came with your hood. Before sending in this card, please write these numbers here:
Model Number | Serial Number |
Use these numbers in any correspondence or service calls concerning your hood.
GREASE FILTER | Push out on this clip |
| to remove filter. |
|
|
Your hood is equipped with a metal grease filter. When the fan is operated, air is drawn through the filter and discharged to the outside.
●Remove the Grease Filter. (See instructions on page 2.)
●Remove the wrappings from the filter.
●Install the lamp bulb (not provided). See Lamp Replacement instructions on page 2.
●Reinstall the Grease Filter. The hood must not be operated without the filter in place.
●Remove transparent protective film from the front trim (except Models JV322J and JV332J).
T’brn the page for Operation and Maintenance instructions.
GE Quality Product
