To Operate
LAMP SWITCH | FAN SWITCH |
Lamp Switch
For models JV322 and JV332, switch has OFF and ON positions. For other models, CENTER position OFF, LEFT position NIGHT LIGHT, RIGHT position
BRIGHT LIGHT.
Fan Switch
CENTER position OFF, LEFT position LOW SPEED, RIGHT position HIGH SPEED.
To Maintain
Grease Filter
The efficiency of your hood depends on a clean filter. Frequency of cleaning depends on the type of cooking you do. BUT GREASE FILTER SHOULD BE CLEANED AT LEAST ONCE A MONTH. NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE.
To remove: Press outward on spring clip, pull down and snap out filter.
To clean: Soak and then agitate in a hot detergent solution. Light brushing may be used to remove imbedded soil. Rinse, shake and remove moisture before replacing.
With careful handling, the filter will last for years. If replacement becomes necessary, order part number WB02X2052 from your dealer.
To replace: Put the filter rim in and against two clips, push outward on the third clip and press filter upward into place.
Hood
Clean grease laden surfaces of the hood frequently. Use warm detergent solution. About 1 tablespoon of ammonia may be added to the water. TAKE CARE TO NOT COME IN CONTACT WITH FILTERS AND OTHER
CAUTION: Be certain when cleaning hood surfaces you do not touch lamp bulb with moist hands or cloth. A warm or hot lamp bulb may break if touched with a moist surface. ALWAYS let lamp cool COMPLETELY before cleaning around it.
Motor and Fan
To Clean Motor and Fan
1.DISCONNECT THE HOOD POWER SUPPLY AT THE HOUSEHOLD DISTRIBUTION PANEL BY REMOVING THE FUSE OR SWITCHING OFF THE CIRCUIT BREAKER.
2.Remove filter.
3.Wipe fan blade and motor with cloth, dampened only in ammonia and warm water solution.
4.Replace filter.
5.Reconnect the hood power supply.
Lamp Replacement
Models JV324J, JV334J,
.IV334R, JV335R, JV624J, JV634J, JV634R and JV635R have a lamp cover.
The lamp cover need not be removed for lamp removal or installation.
CAUTION: Let lamp cool completely before removing. A warm or hot bulb may break if touched with a moist cloth or hand.
Remove lamp and replace with an ordinary
To remove lamp cover, if desired:
●Press the sides with two fingers until the side prongs are released.
. Lift lamp cover and slide towards you in one motion.
To replace lamp cover:
●Insert prong located at end of cover into top opening.
●Gently push cover up and press sides to fit side prongs into the side openings.
●Release and cover will lock in position.
U.L. Requirement
WARNING: THE ELECTRICAL WIRING AND FAN MOTOR IN THIS RANGE HOOD ARE NOT INTENDED FOR USE WITH, OR PROVIDED WITH A SOLID STATE SPEED CONTROL. ANY SUCH ALTERATION FROM ORIGINAL FACTORY WIRING CONCEPT COULD RESULT IN DAMAGE TO THE UNIT AND/OR CREATE AN ELECTRICAL SAFETY HAZARD.
2
