Camera Browser Interface | Interfaces en 85 |
|
|
14.2.4Relay name
The relay can be assigned a name here. The name is shown on the button next to Trigger relay. The LIVEPAGE can also be configured to display the name next to the relay icon.
14.2.5Trigger relay
Click the button to switch the relay manually (for example, for testing purposes or to operate a door opener).
14.3COM1
For cameras with a data connector, use this menu to configure the data transfer.
14.3.1Serial port function
Select a controllable unit from the list. If you wish to use the serial port to transmit transparent data, select Transparent. Select Terminal if you wish to operate the unit from a terminal. After selecting a unit, the remaining parameters in the window are set automatically and should not be changed.
14.3.2Camera ID
If necessary, enter the ID of the peripheral you wish to control (for example a dome camera or pan/tilt head).
14.3.3Baud rate
Select the value for the transmission rate in bps.
14.3.4Data bits
The number of data bits per character cannot be changed.
14.3.5Stop bits
Select the number of stop bits per character.
14.3.6Parity check
Select the type of parity check.
14.3.7Interface mode
Select the desired protocol for the serial interface.
Bosch Security Systems | Software manual |