AutoDome Modular Camera SystemTrouble Shooting Guide en 21
Picture is dark | 1. | Check that the Gain Control is set to AGC. |
|
| If O.K., then: |
| 2. | Check that the ALC level is set to the appropriate level. |
|
| If O.K., then: |
| 3. | Check that the video coax is terminated with 75 Ω only at the head end. (Double ter- |
|
| mination causes dark video.) |
|
| If O.K., then: |
| 4. | Check that the camera lens cover is removed. |
|
| If O.K., then: |
| 5. | Check that the maximum coax distance has not been exceeded. See the AutoDome |
|
| Modular Camera System Installation Manual. |
|
| If O.K., then: |
| 6. | Restore all camera settings using the Install Menu. |
|
|
|
Colors are not correct | 1. | Reset the White Balance to the appropriate selection. |
|
| If O.K., then: |
| 2. | Check that the maximum coax distance has not been exceeded. See the AutoDome |
|
| Modular Camera System Installation Manual. |
|
| If O.K., then: |
| 3. | Restore the White Balance setting to ATW in the Color Menu. |
|
|
|
Background is too | 1. | Turn on backlight compensation (BLC). |
bright to see subject | 2. | Adjust the BLC level. |
| 3. | Adjust the BLC area. |
|
|
|
Video is rolling, noisy | 1. | Ensure that the Sync Mode is set to Internal (crystal ). |
or distorted |
| If O.K., then: |
| 2. | Check that the maximum coax distance has not been exceeded. See the AutoDome |
|
| Modular Camera System Installation Manual. |
|
| If O.K., then: |
| 3. | Check the integrity of all BNC connectors and splices. |
|
| Note: Connecting a network cable to the interface board of a |
|
| video distortion. |
| 4. | Remove network cable from the interface board |
|
|
|
Day/Night camera does | 1. | Check that the Day/Night mode is set to AUTO. |
not switch automati- |
| If O.K., then: |
cally when image is | 2. | Set Gain Control to AGC. |
dark. |
|
|
|
| |
Inside of EnviroDome | If using a Bosch power supply box: | |
bubble is foggy. | 1. | Check the FX103 fuse in the Bosch Power Supply Box for power (24 V) to the heater |
|
| module. |
|
| If O.K., then: |
| 2. | Check all wiring and connector pins to the heater module. |
| If using a | |
| 3. | Confirm that the power supply meets the Bosch AutoDome power ratings. See the |
|
| AutoDome Datasheet for specifications. |
|
| If O.K., then: |
| 4. | Check the mains input line voltage. |
|
| If O.K., then: |
| 5. | Check that the maximum wire length from the power supply has not been exceeded. |
|
| See the AutoDome Modular Camera System Installation Manual. |
|
|
|
Bosch Security Systems, Inc. | F01U028033 2.0 2007.03 |