Bosch Appliances NTC-265-PI installation manual Camera positioning

Page 19

IP Camera 200 Series

Installation en 19

 

 

3.7.1Camera positioning

The camera position can be adjusted along three axes. When adjusting ensure that the picture display on the monitor is level.

Set the camera to the desired position using the supplied Torx screwdriver:

1.For vertical adjustment (1), loosen the locking screw and move the camera housing to the desired angle. Tighten the screw.

2.For horizontal adjustment (2), loosen the locking screw and rotate the camera housing around the base. Tighten the screw.

3.To obtain a horizontal horizon (3), rotate the camera body as necessary to align the picture shown on the monitor.

Bosch Security Systems

Installation Manual

AM18-Q0610 v1 2012.02

Image 19
Contents IP Camera 200 Series Page Table of Contents Technical Data MaintenanceSafety precautions SafetyImportant safety instructions FCC & Ices Information FCC & Ices complianceMore information UL certificationBosch notices DisclaimerCopyrights Introduction FeaturesCD ROM UnpackingAssembly InstallationMounting the camera MountingRJ45 Ethernet PoE Network and power connector12 VDC Power connectionFunction Wire Color I/O connectorAudio connectors Audio connectorsCamera set-up Camera positioning Resetting the camera System requirements Browser connectionProtected network Establishing the connectionMalfunction Possible causes Solution TroubleshootingResolving problems Customer serviceRepairs MaintenanceSpecifications Technical DataAccessories Page Bosch Security Systems