10 en Safety | Integrated IR Dome Camera |
to correct the interference by one or more of the following measures:
–Fit Ferrite beads on all cable to and from the power supply box, within the box walls.
–Route the composite cable between the camera and the power supply in steel conduit piping over the entire run of the cable up to and including connection to a deep conduit base fitted under the camera and a conduit fitting adaptor in the wall of the PSU box.
–Consult a Bosch Service Center for further advice. Intentional or unintentional modifications, not expressly approved by the party responsible for compliance, shall not be made. Any such modifications could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio/television technician for corrective action.
The user may find the following booklet, prepared by the Federal Communications Commission, helpful: How to Identify and Resolve
Informations FCC et ICES
(modèles utilisés aux
TBD 2.0 2010.12 | Installation Manual | Bosch Security Systems, Inc. |