Panasonic PCF2, PCV6W, PCF6W, PCV2 manual Base, Tabs, Dome Replacement, Camera Adjustment

		DOME REPLACEMENT
Camera swivel plate		1. Rotate the liner inside the dome, so that when the dome is
		secured to the base, the camera lens is in the center of the
		viewing slot of the liner.
		NOTE: It may be helpful to install the dome without the liner
		the first time. This way you can visually determine
		which direction the lens is pointing and adjust the liner
		opening accordingly.
		2. Align and insert the three tabs of the dome with the three tab
		slots on the dome base. Rotate the dome clockwise until the
		dome locks into place.
Camera Adjustment	Camera Mount with
Arm	Camera and PC Board
CAMERA ADJUSTMENT
1. Clip the tabs of the template onto the swivel plate so that the
template is attached to the swivel plate.
2. Loosen the two 4-40 Phillips head screws, adjust the camera to
the desired position, and tighten the screws.
Note: Adjust camera lens as close as possible to the outline of		Base
the bottom of the template.
Loosen screws to adjust camera
Tab	Tab
Place the lens as close to		Liner
this edge as possible
		Tabs
Camera Adjustment Template
3. Fine focusing (see diagram below):
Fixed Lens: Manually rotate the lens until a clear picture is
achieved.		Dome
Vari-Focal Lens: First, adjust the Magnification Lock Screw
to the desired magnification (telephoto
to wide angle). Tighten the Lock Screw.
Next, adjust the Focus Lock Screw until a
clear picture is achieved. Tighten the
Lock Screw.
Fixed Lens Camera		Connections
(PCF2, PCF6)
		Video
		BNC Connectors
	Vari-Focal Lens Camera
	(PCV2, PCV6)
Manual focus
		Power Connections
Focus Lock Screw		NOTE: Splice wiring according to
	Magnification	standard electrical guidlines.
	Lock Screw	Positive and Negative connections are
		interchangeable with this PC Board.
	- 2 -