Mount the Camera

Please refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before mounting.

1. Place the mounting bracket where you want to

position the camera and use a pencil to mark1 the holes.

2. Depending on the material of the wall or ceiling,
use proper tools to drill two holes or screws	2

where you marked. If the wall is made out of concrete, drill the holes first, then insert the plastic anchors to support the screws.

3.	The power and Ethernet cables can be	3
	concealed behind the mounting bracket. Run	3
	the cables through the back of the mounting
	bracket, securing them with the built-in
	guides. Be sure to leave enough cable length
	protruding from the top to allow connection to
	the camera.
4.	Fasten the mounting bracket to the wall using	4
	the screws provided.
5.	Using the supplied thumbscrew, fasten the	5
	camera to the mounting bracket. Connect the
	power and Ethernet cables to the camera.
6.	Adjust the angle of the arm on the mounting	6
	bracket as required. Tighten the thumbscrew to

lock the arm in place.

Do not overtighten the screws as this may crack the bracket.

ENGLISH