Cisco Systems OL-3995-01 manual Controlling and Setting the Video Position

Chapter 4 Using IP/TV Viewer

Playing a Program

Controlling and Setting the Video Position

Control the position of the video for an on-demand program while you are watching it by using the following on-demand VCR controls:

•Jump To Beginning button

•Jump Back button

•Jump Forward button

•Jump To End button

•Position Control slider bar

•Change Play Position option

The Jump To Beginning button positions the video back to its beginning with a time offset of zero.

Note You may not always be able to view the actual or true beginning of the video until audio and video synchronization is achieved.

The Jump Back button positions the video back in time 10 percent of the overall duration of the program. If there is less than 10 percent preceding the current position, the program is set to position zero.

The Jump Forward button positions the video forward in time 10 percent of the overall duration of the program. If there is less than 10 percent remaining from the current position, the program is set to its end.

The Jump to End button positions the video to its end.

The Position Control slider bar lets you fast-forward or rewind video segments while watching the program. Slide the bar to the right to fast-forward, or slide it to the left to rewind. The highest possible precision of the slider is measured in seconds. Whenever you move the mouse over the Position Control slider bar, the Position button appears above the control. This button shows the time (hh:mm:ss) in terms of video location. Moving the slider bar updates the time shown on the Position button. Releasing the slider bar causes the program to seek that new location in time.

	Cisco IP/TV Viewer User Guide
OL-3995-01		4-13