Audiovox VC-600 user manual Installation, Channel Selection

water to wipe off any dust, if necessary.

sDo not touch the CCD sensor. If necessary, use a soft, lint-free cloth moistened with alcohol to clean the CCD sensor.

sIf the camera does not operate properly, unplug the unit and contact your local dealer.

6.Installation

sSelect base to be used.

s Screw the camera to the base. If using the wall mount, screw the base to the wall before attaching camera.

s Carefully screw the antenna to the camera.

s Plug the AC/DC adapter into the camera Power Jack and then into the wall.

s Set channel select switch to the corresponding channel of the receiver.

sAdjust the camera for best viewing angle.

7.Channel Selection

After connecting and turning on the equipment, select the channel that gives the best reception and least interference. The channel number must match the channel number of the receiver. The antenna is normally positioned vertically but its angle may be changed to obtain the best reception.

8.	CHANNEL		CH1	CH2	CH3	CH4
S
p	FREQUENCY		2413 MHz	2432 MHz	2451MHz	2470 MHz
e
	OUTPUT	POWER	10 mW
c
i	OUTPUT	IMPEDANCE	50 ohms typical
f	P O W E R		12 VDC supplied by AC/DC adapter
i	CURRENT		260 mA
c	VIDEO OUTPUT		1Vp-p composite video (75 ohms)
a
t	AUDIO OUTPUT		2Vp-p max
i	DIMENSIONS		L: 77mm H: 56mm	D: 56mm
o	OPERATING TEMPERATURE		-10° C to +50° C
n
s	WEIGHT		115 grams
			2

128-5680

2 of 4