Network Settings
Any changes made on this page will restart the system in order to validate the changes. Make
sure every field is entered correctly before clicking on 
.
Network Type
LAN & PPPoE:
The default type is LAN. Select PPPoE if using ADSL
Get IP address automatically
&Use fixed IP address:
The default status is Get IP address automatically. This can be tedious having to perform software installation whenever the Network Camera starts.
Therefore, once the network settings, especially the IP address, have been entered correctly, select Use fixed IP address then the Network Camera will skip installation at the next boot. The Network Camera can automatically restart and operate normally after a power outage. Users can run IP installer to check the IP address assigned to the Network Camera if the IP address is forgotten or using the UPnP function provided by the Network Camera (MS Windows XP provides UPnP function at My Network Place).
IP address: This is necessary for network identification.
Subnet mask: This is used to determine if the destination is in the same subnet. The default value is “255.255.255.0”.
Default router: This is the gateway used to forward frames to destinations in a different subnet.
-18 -
www.4XEM.com