INSTALLATION INSTRUCTIONS
Tools and Parts
Tools Needed
Required Cutout Dimensions
For minimum depth requirements, see chart.
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
■ | Measuring tape | ■ | Drill |
■ | Pencil | ■ | 7/64" drill bit |
■Phillips screwdriver
Parts Supplied (not shown to scale
17" (43.2 cm)
min.
17¹⁄₈" (43.5 cm)
max.
3" (7.6 cm)
6" |
(15.2 cm) |
23¹⁄₈" (58.7 cm) |
1¹⁄₁₆"
(2.7 cm)
A
1¹⁄₁₆" (2.7 cm)
B
Rails (2) | Bottom duct | Trim kit frame |
Short screws (14) | Long wood screws (6 - painted) |
(11 + 3 extra) | (4 + 2 extra) |
|
|
|
|
Location Requirements
The microwave oven may be installed over a
The microwave oven may also be installed in a cabinet by itself (without a
Make sure the surrounding cabinetry has clearance to open and close freely. Allow a clearance of at least 1⁹⁄₁₆" (4.0 cm) below the cutout floor (3" [7.6 cm] for installation above a
| A | |
2" | 2" | |
(5.1 cm) | (5.1 cm) | |
B | B | |
1⁹⁄₁₆" | 3" | |
(4.0 cm) | ||
(7.6 cm) | ||
| ||
| C | |
D | 36" | |
(91.4 cm) | ||
| ||
E |
|
A. Upper cabinet | D. Lower cabinets |
B. Microwave oven cutout | E. Floor |
C. Lower oven cutout |
|
DC
A.Trim kit frame overhang
B.Cutout for lower oven
C.Recommended region for receptacle location (no less than 6" [15.2 cm] to the right of cutout centerline)
D.Cutout centerline
Receptacle Location | Minimum Depth |
Within recommended | 18" (45.7 cm) with flush receptacle; |
region | 21" (53.2 cm) with |
| |
|
|
Outside recommended | 19¹⁄₂" (49.5 cm) with flush receptacle; |
region | 22¹⁄₂" (57.2 cm) with |
| receptacle |
|
|
NOTES:
■Depth requirements depend upon receptacle and its location within or outside of recommended region. See illustration and chart above.
■Height dimension is critical: 17" (43.2 cm) minimum, 17¹⁄₈" (43.5 cm) maximum.
■Width measurement has ±1/16" (2 mm) tolerance.
■3" (7.6 cm) minimum dimension is from lower oven cutout ceiling to microwave oven cutout floor.
■Trim kit frame extends 1¹⁄₁₆" (2.7 cm) above and below the cutout opening.
2