Getting Started
Using the Remote Control
To load a battery in the remote:
1.Pull in the direction of the arrow
2.Slide the compartment out
3.Place the battery in the compartment with the positive side ( + ) facing up
4.Push the compartment in to close
1 | 2 | 3 | 4 |
To use the remote:
•Point the remote at the remote sensor of the photo frame at a distance of no more than 15’ and at an angle no greater than 60 degrees.
•Batteries will last for about one year under typical usage. Replace the batter- ies if the remote is no longer working.
•Do not spill water on the remote control.
•Do not use the remote control for other equipment at the same time.
•Remove the batteries if the remote control will not be in use for an extended period of time.
The battery used in this device may present a fire or chemical hazard if mistreated. Do not recharge, disassemble, incinerate, or heat the batteries.
Used batteries should be disposed of safely and not incinerated. Attention should be shown to the environment aspects of battery disposal.
Keep batteries out of the reach of children.
Page 14 | Coby Electronics Corporation |
|
|