If you encounter any trouble to boot you system, follow the procedures accordingly to resolve the problem.
Part Number and Serial Number
The Part Number and Serial number are printed on bar code label. You can find this bar code label on the outside packing, on ISA/CPU slot or on component side of PCB. For example:
Start
Turn off the power and unplug the AC power cable, then remove all
of the addon cards and cables, including VGA, IDE, FDD, COM1, COM2 and Printer.
Make sure if the jumper settings for CPU and DRAMs are correct.
Clear CMOS.
Install the VGA card. Then connect your monitor and keyboard.
Turn on the power, and check if |
| No | |
the power supply and CPU fan |
|
| |
work properly. |
|
| |
| Yes |
|
|
Check if there is display. |
| No | |
|
| ||
| Yes |
|
|
|
|
| |
Press Ctrl, and Alt key at the |
| No | |
same time, hold them and then |
|
| |
press Del to see if the |
|
| |
system reboots. |
|
| |
Yes
During system rebooting, press Del to enter BIOS Setup. Choose “Load Setup Default".
Turn off the system and | No |
re- connect the IDE cable. |
|
Check if the system can |
|
reboot successfully. |
|
The problem was probably caused
by power supply or motherboard failure. Please contact your reseller
or local distributor for repairing.
Perhaps your VGA card or monitor is defective.
It is very possible that your keyboard is defective.
The problem should be caused by the IDE cables or HDD itself.
Part No. | Serial No. |
|
|
|
Part No. | Serial No. | |
P/N: 91.88110.201 is part number, S/N: 91949378KN73 is serial num ber.
Yes
Re- install Windows 95, Windows 98 or Windows NT.
End