Kenwood XD-980MD Before applying power, Safety precautions, For the United Kingdom

Page 2

2Before applying power

Units are designed for operation as follows.

Europe and U.K

AC 230 V only

For the United Kingdom

 

 

Factory fitted moulded mains plug

 

 

1. The mains plug contains a fuse. For replacement, use only a 13-Amp

 

 

ASTA-approved (BS 1362) fuse.

 

 

2. The fuse cover must be refitted when replacing the fuse in the

 

 

moulded plug.

 

 

 

3. Do not cut off the mains plug from this equipment. If the plug fitted

 

 

 

 

is not suitable for the power points in your home or the cable is too

section

 

short to reach.

 

 

A power point, then obtain an appropriate safety approved extension

 

 

 

 

lead or adapter, or consult your dealer.

Preparation

 

If nonetheless the mains plug is cut off, remove the fuse and

 

dispose of the plug immediately, to avoid a possible shock hazard by

 

 

 

 

inadvertent.

 

 

 

Connection to the mains supply.

 

 

IMPORTANT : The wires in the mains lead are coloured in accordance

 

 

with the following code :

 

 

Blue

: Neutral

 

 

 

 

Brown

: Live

 

 

Do not connect those leads to the earth terminal of a three-pin plug.

 

 

 

 

Caution : Read this page carefully to ensure safe operation.

XD-980MD (En)

Safety precautions

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI- FIED SERVICE PERSONNEL.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN- TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.

REQUIREMENT BY NEDERLAND GAZETTE

Batteries are supplied with this product. When they empty, you should not throw away. Instead, hand them in as small chemical waste.

The marking of products using lasers

(Except for some areas)

CLASS 1

LASER PRODUCT

The marking is located on the rear panel and says that the com- ponent uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents XD-980MD Marking of products using lasers Except for some areas Before applying powerSafety precautions For the United KingdomContents Knowledge sectionConvenient timer functions Special features An MD recorder is standard equipmentVersatile tone and sound field adjustment SRS 3D stereo systemDiscs which can be played with this unit Disc handling precautionsHandling of discs Handling of Mini DiscConnection of the System Accessories System connectionSpeaker left Malfunction of microcomputerFM indoor antenna Speaker UnitSurround speakers RS-N750 Regard to the Surround switchMain Unit Cassette deck X-H9FM outdoor antenna Controls and indicators Main unitCD player section Amplifier/Tuner sectionMD Recorder Section 1ON/STANDBYRunning Indicator Display amplifier and tuner sectionControls and indicators 1 Display MD recorder sectionRemote control Unit 8ON/STANDBYOperation Operation of remote control unitLoading batteries Remove the cover Insert batteries Close the coverBasic use method Volume adjustmentLets put out some sound Selecting the desired outputAuto Power Save function Muting the sound temporarily Remote control unit onlyListening through headphones Standby mode of ON/STANDBY keyStart playback Playback of CDLoad a disc Lets put out some soundTo pause playback Skipping tracksPlayback from desired track To stop playbackPlayback of Mini Disc Load a Mini DiscEjecting the disc Disc recorded in monaural modeSearching in a track Lets put out some sound 2Press the Title Search key Confirm that the PGM indicator is not litRegard to automatic title search Select the desired titleRegard to Display Mode key Regard to the Time Display keySelect a station Receiving broadcast stationSelect the broadcast band Each press changes the bandSelect the tuning mode Collective presetting of stations auto presetOne-by-one presetting manual preset M 8 MHzSelect the source to be recorded Lets recordingMake the preparations for recording Only analog recordingPause the recording Adjust the recording level only analog recordingStart recording Regard to display messagesTips for recording from a CD How to use the REC Input keyHow to use the AUTO/MANU. key Auto2 P- 2 Playback of CD1 @ To add a track to the program To quit the program modeTo check the programmed tracks To repeat all discs Repeated playbackTo repeat a disc To stop repeated playbackPress the Repeat key three times To repeat only one trackTo repeat only the programmed tracks To cancel random playback Confirm that the PGM indicator is not litSelect the Random mode To select another track in the middle of playing oneListening in the desired sequence program playback 1Let the PGM indicator lightPlayback of MD 3Start playbackPlayback of MD 3 Checking the order of tracksTo clear tracks from the program 1Make the PGM display go out Let the Repeat indicator lightTo repeat the entire disc C 1 FM To switch the display contentsS. Radio Data System 1 2 MHzPTY search Select the PTY search modeW s 2Select the desired program typeTo change to a different program type When a station is receivedStart the search Repeat steps 1, 2M 9 . MHz Auto preset the stationsMHz Select the desired informationRegard to TP Traffic Program indicator Wait for the desired informationConvenient Recording Methods Best HitsOne-touch recording of one CD, MD When a desired track is found, only that track is recordedFade-in/fade-out Producing a tape collecting only the first titlesConvenient Recording Methods Make the preparations for recordingStart recording At the end of the recording One-touch edit recording of one trackTo interrupt a recording Convenient Recording Methods 44Exchange discs as required 1 1 5Press the Best Hits key To end recordingExchange the two discs Exchange discs as requiredTo stop recording 2Close the tray4Start edit recording 2 3Program recording Recording preparation is requiredRecording of one CD or several CDs CD =TAPE C C R s CD =TAPE only Time edit recordingTo check the edited contents To clear the edited contentsFade edit recording Make sure that the PGMindicator is offFade-out/Fade-in at the tape reversal CD =TAPE only Select the discErasing tracks MD Edit FunctionsDividing a track, combining two tracks Regard to display scrollingInput the title 1Activate the title input modeAssigning a title to a disc or track Execute title assignmentExecute title change or deletion Changing or deleting a titleTotal number of title characters MD Edit Functions 5Select the range of tracks to be reordered Moving several tracks at a time Quick MovePress the Quick Move key Execute the track move operationSelect the track to be moved Moving a single track Track MoveSelect Move Select the moving destination trackExecute the track divide operation Dividing a track Track DividePlay the track to be divided Divide ?2Select the track to be combined Combining two tracks Track CombineSelect Combine Execute the track combine operationTo erase all tracks ALL Erase Select the Erase modeMake the preparations To erase one track Track Erase Execute the erase operationErasing a part of a track Adjust Adjustment of balance and input levelSelect what to adjust Regard to equalizer adjustment LOW, MID, HighEqualizer function C KN U a L 1 Regard to demonstrationDesired equalizer pattern can be created and memorized Adjust the equalizer patternMemorize the setting Select the number to be recordedS 3 D O N Adjust the effect strength levelExperiencing SRS 3D Stereo Sound Retrieval System 2Play the music Enjoying KaraokeConnect a microphone 3Sing along with the accompanimentHIT Master on HIT Master OFF Effective Sound Field and Sound Quality Adjustment 6Each press switches on and OFF alternately Enter the figure of hour Clock adjustmentActivate the clock adjustment mode 3Enter the figure of minuteSleep timer Timer operationOperate easy To use Timer O.T.T To cancelMake preparations for the play recording Timer programmingAdjust the listening volume Set the ON/STANDBY key to Standby position5Enter the on time Select the timer program No. to be usedAdjust the clock before setting the timer Enter the OFF timeWhen timer operation is not required Check the reservation contentTo change the reserved contents To set the same timer program againReference MaintenanceImportant Items MD system Important ItemsDigital recording and Scms Case of difficulty Operation to resetSymptom Cause Remedy Amplifier section/SpeakersSymptom Cause MD recorder section other symptomsSymptoms related to MD standard Case of difficultyMemory Backup for the MD Recorder Section CD player section in regard to message display Remote control unitSymptom For your records SpecificationsMain unit RXD-980MD Speakers LS-N750

XD-980MD specifications

The Kenwood XD-980MD is a distinguished mini component stereo system that has garnered attention for its robust performance and user-friendly design. This compact system brings an array of features and technologies suited for audiophiles and casual listeners alike.

One of the standout features of the Kenwood XD-980MD is its integrated MD (MiniDisc) player, which marked a significant advancement in portable audio storage during the late 1990s and early 2000s. The ability to record and play back high-quality audio on MiniDiscs provided users with options beyond traditional CD formats, enhancing the versatility of the system. The inclusion of a CD player also allows for seamless playback of standard audio CDs, making it suitable for various media formats.

The XD-980MD is equipped with a powerful amplifier that delivers dynamic sound performance with a total power output of around 100 watts. This ensures that even the most demanding tracks are played with clarity and depth, producing rich bass and crisp highs that can fill a room. The system also features a bass boost option, allowing users to tailor the audio output to their personal preferences.

In terms of connectivity, the Kenwood XD-980MD is well-equipped with a range of inputs, including line-in and phono inputs, which enable the connection of external devices such as turntables and smartphones. The presence of a built-in FM/AM tuner adds further versatility, allowing users to enjoy live radio broadcasts without requiring additional equipment.

Another notable characteristic of the XD-980MD is its user-friendly interface. The system features an easy-to-read LCD display that provides information on track details, radio stations, and settings, ensuring a hassle-free experience. The remote control included with the system enhances convenience, allowing users to navigate tracks and adjust settings from a distance.

In conclusion, the Kenwood XD-980MD stands out as a comprehensive mini stereo system that caters to diverse listening preferences. With its combination of MD and CD playback, powerful amplification, extensive connectivity options, and user-friendly design, it remains a popular choice for those seeking quality audio performance in a compact form factor. Whether you're enjoying classic vinyl records or modern digital tracks, the XD-980MD delivers an exceptional listening experience.
Top Page Image Contents