Kenwood XD-980MD Case of difficulty, Operation to reset, Amplifier section/Speakers

Page 76

7 6 In case of difficulty

XD-980MD (En)

Operation to reset

The microcomputer may fall into malfunction (impossibility to operate, erroneous display, etc.) when the power cord is un- plugged while unit is ON or due to an external factor. In this case, execute the following procedure to reset the microcom- puter and return it to normal condition.

÷Please note that resetting the microcomputer clears the contents stored in and it returns to condition when it left the factory.

Use a pointed object to reset.

RESET

°￿

Amplifier section/Speakers

Symptom

Cause

Remedy

 

Sound is not produced.

÷ The speaker cords are disconnected.

÷ Connect properly referring to “System con-

6

 

 

nections”.

^

 

÷ The volume control is set to the minimum

÷ Adjust to an required volume.

 

position.

 

 

 

÷ The MUTE key of remote control unit is

÷ Switch MUTE OFF.

 

 

switched ON.

 

 

 

÷ The headphone plug is inserted into the

÷ Unplug the headphone plug.

 

 

jack.

 

8

 

÷ The system connection cord is discon-

÷ Check the connection of the system con-

 

nected.

nection cord.

 

 

 

 

 

“PROTECT” is displayed and no sound is

÷ The speaker cords are short-circuited.

÷ Turn the unit OFF, remove the short-circuit

 

put out.

 

and turn the unit ON again.

 

 

 

 

 

No sound from the headphones.

÷ Imperfect insertion.

÷ Insert correctly.

&

 

 

 

 

Sound is not produced from the left or

÷ The speaker cords are disconnected.

÷ Connectproperlyreferringto“Systemconnection”.

8

right speakers.

÷ The BALANCE is set completely to the left

÷ Adjust the optimum left and right balance.

ã

 

or right channel.

 

 

 

 

 

 

Tuner section

 

 

Symptom

Cause

Remedy

 

 

 

 

 

 

 

 

 

The clock display blinks without chang-

÷ There was a power failure.

÷ Adjust the present time again.

ö

 

 

ing the figures.

÷ The power cord was unplugged from the

÷ Adjust the present time again.

 

 

 

 

outlet.

 

 

 

 

 

 

 

 

 

 

Timer operation is not possible.

÷ The present time has not been adjusted or

÷ Adjust the present time referring to “Clock

 

 

 

 

there was a power failure.

adjustment”.

∏

 

 

 

÷ The timer ON time and OFF time have not

÷ Set the timer ON time and OFF time.

 

 

 

been set.

 

 

 

 

 

÷ The timer execution was not set up.

÷ Press the SRS 3D key to set up the execution.

 

 

 

 

 

 

 

 

 

Radio stations cannot be received.

÷ The antennas have not been connected.

÷ Connect antennas.

6

 

 

 

÷ A proper broadcasting band has not been

÷ Select a band.

¢

 

 

 

selected.

 

 

 

 

 

÷ The frequency of the station to be received

÷ Tune to the frequency of the desired sta-

 

 

 

 

is not tuned.

tion.

 

 

 

 

 

 

 

 

 

Noise interferes.

÷ Car ignition noise.

÷ Install the outdoor antenna in an apart posi-

 

 

 

 

 

tion from the road.

 

 

 

 

÷ Influence of an electric appliance.

÷ Switch the suspected electric appliance

 

 

 

 

 

OFF.

 

 

 

 

÷ A TV set is installed near the system.

÷ Install the TV or the system at an increased

 

 

 

 

 

distance between them.

 

 

 

 

 

 

 

 

 

A station has been preset but it cannot

÷ The frequency of the preset station is not

÷ Preset stations with tunable frequencies.

 

sections

 

be received by pressing the P.CALL key.

tunable.

÷ Preset stations again.

∞

 

 

for a long period.

 

 

 

÷ The preset memory has been cleared be-

 

 

 

cause the power cord has been unplugged

 

 

Knowledge

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 75 Page 77
Image 76
Page 75 Page 77
Contents XD-980MD Before applying power Safety precautionsMarking of products using lasers Except for some areas For the United KingdomContents Knowledge sectionSpecial features An MD recorder is standard equipment Versatile tone and sound field adjustmentConvenient timer functions SRS 3D stereo systemDisc handling precautions Handling of discsDiscs which can be played with this unit Handling of Mini DiscConnection of the System Accessories System connectionMalfunction of microcomputer FM indoor antennaSpeaker left Speaker UnitRegard to the Surround switch Main UnitSurround speakers RS-N750 Cassette deck X-H9FM outdoor antenna Controls and indicators Main unitAmplifier/Tuner section MD Recorder SectionCD player section 1ON/STANDBYRunning Indicator Display amplifier and tuner sectionControls and indicators 1 Display MD recorder sectionRemote control Unit 8ON/STANDBYOperation of remote control unit Loading batteriesOperation Remove the cover Insert batteries Close the coverVolume adjustment Lets put out some soundBasic use method Selecting the desired outputMuting the sound temporarily Remote control unit only Listening through headphonesAuto Power Save function Standby mode of ON/STANDBY keyPlayback of CD Load a discStart playback Lets put out some soundSkipping tracks Playback from desired trackTo pause playback To stop playbackPlayback of Mini Disc Load a Mini DiscDisc recorded in monaural mode Searching in a trackEjecting the disc Lets put out some sound 2Confirm that the PGM indicator is not lit Regard to automatic title searchPress the Title Search key Select the desired titleRegard to Display Mode key Regard to the Time Display keyReceiving broadcast station Select the broadcast bandSelect a station Each press changes the bandCollective presetting of stations auto preset One-by-one presetting manual presetSelect the tuning mode M 8 MHzLets recording Make the preparations for recordingSelect the source to be recorded Only analog recordingAdjust the recording level only analog recording Start recordingPause the recording Regard to display messagesHow to use the REC Input key How to use the AUTO/MANU. keyTips for recording from a CD Auto1 @ Playback of CD2 P- 2 To check the programmed tracks To quit the program modeTo add a track to the program Repeated playback To repeat a discTo repeat all discs To stop repeated playbackTo repeat only the programmed tracks To repeat only one trackPress the Repeat key three times Confirm that the PGM indicator is not lit Select the Random modeTo cancel random playback To select another track in the middle of playing one1Let the PGM indicator light Playback of MDListening in the desired sequence program playback 3Start playbackTo clear tracks from the program Checking the order of tracksPlayback of MD 3 To repeat the entire disc Let the Repeat indicator light1Make the PGM display go out To switch the display contents S. Radio Data SystemC 1 FM 1 2 MHzSelect the PTY search mode W sPTY search 2Select the desired program typeWhen a station is received Start the searchTo change to a different program type Repeat steps 1, 2Auto preset the stations MHzM 9 . MHz Select the desired informationRegard to TP Traffic Program indicator Wait for the desired informationConvenient Recording Methods Best HitsWhen a desired track is found, only that track is recorded Fade-in/fade-outOne-touch recording of one CD, MD Producing a tape collecting only the first titlesStart recording Make the preparations for recordingConvenient Recording Methods One-touch edit recording of one track To interrupt a recordingAt the end of the recording Convenient Recording Methods 41 1 5 Press the Best Hits key4Exchange discs as required To end recordingExchange discs as required To stop recordingExchange the two discs 2Close the tray2 3 Program recording4Start edit recording Recording preparation is requiredRecording of one CD or several CDs CD =TAPE C C R s CD =TAPE only Time edit recordingTo check the edited contents To clear the edited contentsMake sure that the PGMindicator is off Fade-out/Fade-in at the tape reversal CD =TAPE onlyFade edit recording Select the discMD Edit Functions Dividing a track, combining two tracksErasing tracks Regard to display scrolling1Activate the title input mode Assigning a title to a disc or trackInput the title Execute title assignmentChanging or deleting a title Total number of title charactersExecute title change or deletion MD Edit Functions 5Moving several tracks at a time Quick Move Press the Quick Move keySelect the range of tracks to be reordered Execute the track move operationMoving a single track Track Move Select MoveSelect the track to be moved Select the moving destination trackDividing a track Track Divide Play the track to be dividedExecute the track divide operation Divide ?Combining two tracks Track Combine Select Combine2Select the track to be combined Execute the track combine operationSelect the Erase mode Make the preparations To erase one track Track EraseTo erase all tracks ALL Erase Execute the erase operationErasing a part of a track Adjustment of balance and input level Select what to adjustAdjust Regard to equalizer adjustment LOW, MID, HighC K N U a L 1Equalizer function Regard to demonstrationAdjust the equalizer pattern Memorize the settingDesired equalizer pattern can be created and memorized Select the number to be recordedExperiencing SRS 3D Stereo Sound Retrieval System Adjust the effect strength levelS 3 D O N Enjoying Karaoke Connect a microphone2Play the music 3Sing along with the accompanimentEach press switches on and OFF alternately Effective Sound Field and Sound Quality Adjustment 6HIT Master on HIT Master OFF Clock adjustment Activate the clock adjustment modeEnter the figure of hour 3Enter the figure of minuteTimer operation Operate easy To use Timer O.T.TSleep timer To cancelTimer programming Adjust the listening volumeMake preparations for the play recording Set the ON/STANDBY key to Standby positionSelect the timer program No. to be used Adjust the clock before setting the timer5Enter the on time Enter the OFF timeCheck the reservation content To change the reserved contentsWhen timer operation is not required To set the same timer program againImportant Items MaintenanceReference MD system Important ItemsDigital recording and Scms Operation to reset Symptom Cause RemedyCase of difficulty Amplifier section/SpeakersMD recorder section other symptoms Symptoms related to MD standardSymptom Cause Case of difficultyMemory Backup for the MD Recorder Section Symptom Remote control unitCD player section in regard to message display Specifications Main unit RXD-980MDFor your records Speakers LS-N750

XD-980MD specifications

The Kenwood XD-980MD is a distinguished mini component stereo system that has garnered attention for its robust performance and user-friendly design. This compact system brings an array of features and technologies suited for audiophiles and casual listeners alike.

One of the standout features of the Kenwood XD-980MD is its integrated MD (MiniDisc) player, which marked a significant advancement in portable audio storage during the late 1990s and early 2000s. The ability to record and play back high-quality audio on MiniDiscs provided users with options beyond traditional CD formats, enhancing the versatility of the system. The inclusion of a CD player also allows for seamless playback of standard audio CDs, making it suitable for various media formats.

The XD-980MD is equipped with a powerful amplifier that delivers dynamic sound performance with a total power output of around 100 watts. This ensures that even the most demanding tracks are played with clarity and depth, producing rich bass and crisp highs that can fill a room. The system also features a bass boost option, allowing users to tailor the audio output to their personal preferences.

In terms of connectivity, the Kenwood XD-980MD is well-equipped with a range of inputs, including line-in and phono inputs, which enable the connection of external devices such as turntables and smartphones. The presence of a built-in FM/AM tuner adds further versatility, allowing users to enjoy live radio broadcasts without requiring additional equipment.

Another notable characteristic of the XD-980MD is its user-friendly interface. The system features an easy-to-read LCD display that provides information on track details, radio stations, and settings, ensuring a hassle-free experience. The remote control included with the system enhances convenience, allowing users to navigate tracks and adjust settings from a distance.

In conclusion, the Kenwood XD-980MD stands out as a comprehensive mini stereo system that caters to diverse listening preferences. With its combination of MD and CD playback, powerful amplification, extensive connectivity options, and user-friendly design, it remains a popular choice for those seeking quality audio performance in a compact form factor. Whether you're enjoying classic vinyl records or modern digital tracks, the XD-980MD delivers an exceptional listening experience.
Top Page Image Contents