z | A Warning | . | ||
0 | • | The unit can only be used with a12 VDC power supply, negative ground. | ||
..... | • | Disconnect the battery'snegative terminal before wiring and mounting. | ||
1- | ||||
• | Do not connect Battery wire. (yellow) and Ignition wire (red) to the car | |||
u | ||||
| chassis or Ground wire (black) to prevent ashort circuit.. |
| ||
·w |
|
| ||
z | • | Insulate unconnected wires with vinyl tape to prevent ashort circuit. | ||
• | Be sure to ground this unit to the car'schassis again after installation. | |||
z | ||||
A Caution |
| |||
0 |
| |||
• | For s~fety's sake, leave wiring and mounting to professionals. Consult the | |||
u | ||||
| car audio dealer. |
| ||
........... |
|
| ||
z | • | Install this unit in the console of your vehicle. Do not touch the metal | ||
| parts of this unit duringand shortly after use of the unit. | Metal parts such | ||
0 |
| |||
| as the heat sink and enclosure become hot. |
| ||
- |
|
| ||
• | Do not connect the 8 wires of speakers to the car chassis or Ground wire | |||
1- | ||||
c |
| (black), or connect them in parallel. |
| |
.... | • | Connect speakers with amaximum power of more than 50 W. Ifthe · | ||
.... | ||||
| maximum power of the speakers is low~r than 50 W, change the | |||
c |
| |||
| [AMP GAIN] setting to avoid damaging the speakers. (+12) | |||
1- | • | |||
Mount the unit at an angle'ofless than 30°. |
|
.1
Do the required wiring. (+19)
2
Dashboard of your car
z | • | Ifyour vehicle wiring harness does not have the ignition terminal, |
|
| |
"' | connect Ignition wire (red) to the terminal on the vehicle'sfuse box | |
- |
| |
| which provides 12 VDC power supply and is turned on and off by the | |
|
| |
|
| ignition key. |
| • | After the unit is installed, check whether the brake lamps, blinkers, |
| • | wipers, etc. on the car are working properly. |
| If the fuse blows, first make sure the wires are not touching car'schassis, | |
|
| then replace the old fuse with one th~t has the same rating. |
| When installing without the mounting | ||
1 | sleeve | . | |
A Use only the specified screws. Using wrong screws | |||
| |||
| might damage the unit. |
Bend the appropriate tabs to hold the sleeve firmly in place.
How to remove the unit
·Basicprocedure |
1Remove the key from the ignition switch, then disconnect the 8 terminal of the car battery.
2Connect the wires properly.
Flat or round head screws | |||
(not supplied) | X | 3/8 |
|
M5 X 8mm (M5 | ) | ||
|
|
| 11 |
\'<4>......_ |
| . |
|
14>......__ | - |
|
|
8
mm
(3/8")
8
mm
(3/8
")
3 | See Wiring connection. (+19) | · |
Install the unit to your car. |
| |
| See Installing the unit | |
4 | Connect the 8 terminal of the car battery. | |
5· | Reset the unit. (+ 3) | · |
Bracket (not supplied) '.
18