Philips CID3692 user manual Get started, Install the car audio

Page 8

nDISP//

•Adjust screen brightness.

•Turn on/off the screen display.

o

•Built-in microphone for phone calls.

pDisc slot

3 Get started

Caution

•Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Always follow the instructions in this chapter in sequence.

Install the car audio

These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer.

Caution

•This unit is designed for negative ground (earth) 12 V DC operation only.

•Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during use.

•To avoid short-circuit: before you connect, ensure that the ignition is off.

•Ensure that you connect the yellow and red power supply leads after all other leads are connected.

•Ensure that all loose leads are insulated with electrical tape.

•Ensure that the leads do not get caught under screws orin parts that will move (e.g. seat rail).

•Ensure that all ground (earth) leads are run to a common ground (earth) point.

•Use only the supplied mounting hardware for a safe and secure installation.

•Improper fuses can cause damage or fire. When you need to change the fuse, consult a professional.

Note on the power supply lead (yellow)

•When you connect other devices to this system, ensure that the rating of the car circuit is higher than the total fuse value of all the connected devices.

8EN

Page 7 Page 9
Image 8
Page 7 Page 9
Contents =++.  =+&1  Name Parts Hazardous/toxic SubstanceContents Environmental information SafetyRecycling English Introduction Check and identify the contents of your packageWhat’s in the box Overview of the main unit Always follow the instructions in this chapter in sequence Install the car audioGet started Connect GPS antenna Connect wiresNever connect speaker wires with stripes to one another Connect radio antenna Mount in the dashboardSet date and time Adjust screenTurn on Upgrade the map Tap on 12Hr or 24Hr to select clock mode Set time Tap TimeUse map Set date Tap DateTune by frequency Listen to radioTune to a radio station Tune to a preset station Store radio stations in memorySelect radio range Store stations manuallyPlay Load discsConnect USB device Insert USB or SD/MMC cardPlay/Pause Skip/searchSearch within a title/folder Remove the SD/MMC cardRepeat Repeat a sectionRandom play Select audio languageSelect audio mode Select subtitle languageRotate pictures ZoomPlay with Bluetooth device Disconnect Bluetooth devicesMake a call DisplayedListen to music from Bluetooth device Adjust Bluetooth settingsSwitch phone call to the mobile Receive callMute Adjust soundSelect preset equalizer Adjust fader/balance Set Dynamic Bass Boost DBBAdjust settings Display system setup menuAdjust general settings OirtAdjust sound settings Adjust video settingsNtsc PALAdjust language settings Adjust volume settings Adjust DVD ratingReset OthersListen to other devices Remove the unitProduct information Replace fuseDVD AmmwAM MW LCD Troubleshooting About Bluetooth deviceImage flashes or distorted Device cannot be used with the system to play musicSystem is not in the pairing mode Paired mobile phone connects and disconnects constantlyGlossary MMCMP3 Sdhc
Top Page Image Contents