Jabra SP 500 Pair² with your Bluetooth mobile phone, Making a call, Ending a call, Muting a call

English

4“Pair”² with your Bluetooth mobile phone

1.Ensure SP500 is switched on. (See section 3)

2.Press the Pairing button until you see a solid blue light (approximately 2 seconds), then release. Your Speaker phone is now in pairing mode.

3.Set your Bluetooth phone to “discover” the speakerphone by following your phone’s instruction guide. Typically, the steps involve going to a “setup”, “connect”, or “Bluetooth” menu on your phone and then selecting the option to “discover” a Bluetooth device*. (See example from a typical mobile phone in fig. 2)

4.Your phone should find the “Jabra SP500” speakerphone and ask if you want to pair with it. Confirm by pressing “yes” or “ok”.

5.Enter passkey or PIN³ = 0000 (4 zeros), then press “yes” or “ok”

IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly before going back to flashing blue every 3 seconds. You will also hear the confirmation melody. If unsuccessful, the light remains solid, and you’ll need to re-attempt pairing.

(See steps 3–5 above)

USING YOUR Jabra SP500

Before using your Jabra SP500, ensure that the batteries are charged and the Jabra SP500 is paired (see item 3) with your Bluetooth mobile phone and switched on.

The speakerphone can be used while being recharged from a wall socket or from the car charger.

5Making a call

Using your mobile phone’s keypad

1.Dial number on keypad.

2.Press phone’s “send” key.

3.The Jabra SP500 has automatic volume control and will automatically adjust the speaker volume based on the relevant back ground noise. In order to adjust the volume according to your own preferences, use the volume control wheel.

Using voice-dialling (if supported by your phone)

1.Press and release once. You’ll hear one short beep while doing this.

2.You’ll then hear the voice-activation tone; say the name of the person you wish to call.

NOTE: Record voice tag via your mobile phone. If you have a Nokia phone you will be able to record the voice tags via your Speakerphone.

6Ending a call

•Press and release once

OR

•End call from your mobile phone’s keypad

7Answering a call

•After you hear the ring tone, press and release once.

OR

•Answer the call with your mobile phone’s keypad. You may then need to transfer the call to the speakerphone by pressing and releasing once (depending on your phone).

8Muting a call

•To enable mute press the mute button for one second and you will hear a short beep. You’ll see solid yellow light.

To disable mute function press the mute button briefly.

9Call-waiting

•It is recommended that you use your mobile phone’s keypad which typically involves pressing the “send” button.

OR

•Press and hold until you hear two beeps to answer the incoming call and switch between calls (some phones do not support call-waiting via this method).

10Indicator light

To avoid the Jabra SP500’s LED lights from distracting you when driving at night the LED lights will be switched off 1 min after an active call. It is also possible to prevent the LED from flashing by pressing and holding the mute button for 10 seconds until you hear a second beep. The Jabra SP500 will still function during this time. When you switch off the unit and then switch it back on again the LED lights will commence flashing again.

English

4 5