Philips CE132 Connect wires, Always follow the instructions in this chapter in sequence, Lead

3Install the car audio system

Caution

•• Use the controls only as stated in this user manual.

Always follow the instructions in this chapter in sequence.

These instructions are for a typical installation. However, if your car has different requirements, make the adjustment accordingly. If you have any question regarding installation kits, consult your local retailer.

Note

•• This system is designed for negative ground (earth) 12V DC operation only.

•• Always install this system in the car dashboard. Other locations can be dangerous as the rear of the system heats up during use.

•• To avoid short-circuit: before you connect, make sure that the ignition is off.

•• Make sure that you connect the yellow and red power supply leads after all other leads are connected.

•• Make sure that all loose leads are insulated with electrical tape.

•• Make sure that the leads do not get caught under screws iron parts that will move (e.g. seat rail).

•• Make sure that all ground (earth) leads are run to a common ground (earth) point.

•• Use only the supplied mounting hardware for a safe and secure installation.

•• Improper fuses can cause damage or fire. When you need to change the fuse, consult a professional.

•• When you connect other devices to this system, make sure that the rating of the car circuit is higher than the total fuse value of all the connected devices.

•• Never connect speaker wires to the metal body or chassis of the car.

•• Never connect speaker wires with stripes to one another.

Connect wires

Note

•• The ISO male connectors are not supplied.

•• Make sure that all loose leads are insulated with electrical tape.

•• Consult a professional to connect wires as instructed below.

1 Check the car's wiring carefully and connect them to the the ISO male connectors.

	ISO male	Connect to
	connectors
a	Green strip, black-	Rear left speaker
	edged green strip
b	White strip, black-	Front left speaker
	edged white strip
c	Gray strip, black-	Front right speaker
	edged gray strip
d	Purple strip, black-	Rear right speaker
	edged purple strip
e	Red strip	Ignition key +12V
		DC when ON/ACC
f	Blue strip	Motor/electric
		antenna relay control
		lead
g	White-edged blue	Amplifier relay
	strip	control lead
h	Black strip	Ground
i	Yellow strip	To the +12V car
		battery which is
		energized at all times

EN 7