Philips CED780 user manual Mount into the dashboard

	Connector/	Connect to/with
	Object
1	Pink wire	Extension wire
2	2.5m	Parking brake (-)
	extension
	wire (not
	included)

3Brake switch

4Ground

5	Purple wire	Reverse camera
		(B+)

6Gearbox switch

7	Reverse gear	Back lamp lead +
	signal
8	ISO wires	Connected in step
		1 above
9	Yellow cable	Video out
10	Red cable	Rear line out
		(Right)
11	White cable	Rear line out
		(Left)
12	Red cable	Front line out
		(Right)
13	White cable	Front line out
		(Left)
14	Red cable	Audio in (Right)
15	White cable	Audio in (Left)
16	Yellow cable	Video in
17	Brown cable	Camera in
18	Blue cable	Subwoofer
19	White wire	OE remote
20	Black wire	Radio antenna
21	Black wire	External
		microphone
22	Black wire	TV ready/DAB
		ready
23	Black wire	GPS smart
		antenna

Mount into the dashboard

Note E n g l i s h

•• Check wire connection before you mount the unit into a car.

•• If preset radio stations are lost when the ignition key is turned off and then turned on, reconnect the red leads crosswise to the yellow ones.

1 If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery.

	• If you disconnect the car battery in
	a car that has an on-board drive or
	navigation computer, the computer
	may lose its memory.
	• If the car battery is not disconnected,
	to avoid short-circuit, ensure that the
2	bare wires do not touch each other.
	Ensure that car dashboard opening is
	within these measurements:
		5mm
	183	mm
		53mm

•Since the unit cannot be used if the slant angle of dashboard opening is above 20 degrees, ensure that the horizontal slant of the dashboard opening is between 0 and 20 degrees.

EN 15