Connect power, Set clock, Turn on | Philips MCM2050 manual

Connect power

Caution

Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the unit.

Risk of electric shock! When you unplug the AC power cord, always pull the plug from the socket. Never pull the cord.

Before connecting the AC adapter, ensure that you have completed all other connections.

Note

The type plate is located at the back of the main unit.

Connect the power adapter to:

the DC IN socket on the main unit. the wall socket.

1In standby mode, press and hold CLOCK SET on the remote control for two seconds.

»[SET CLOCK] the display.

2Press CLOCK SET again.

» The 12/24 hour format blinks.

3Press / repeatedly to select hour format.

4Press CLOCK SET

» The hour digits blink.

5Repeat steps 3-4 to set the hour.

6Repeat steps 3-4 to set the minute.

7Repeat steps 3-4 to select whether to synchronize time of this unit with RDS stations.

[NO SYNC CLOCK]: time synchronization is deactivated. [SYNC RDS CLOCK]: the unit synchronizes time from the RDS stations automatically.

Note

The accuracy of the transmitted time depends on the RDS station that transmits the time signal.

If no button is pressed in 90 seconds, the unit exits clock setting mode automatically.

Note

To select a source, press SOURCE repeatedly or the source selection buttons on the remote control.

Switch to standby mode

Press again to switch the unit to standby mode.

display panel.

10EN