INSTALLATION
Connection Descriptions
Note: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used a general guideline only.
Power Wire (+12V)
•Disconnect negative battery terminal before proceeding. Consult a qualified technician for instructions if you are unsure.
•Plan wire routing before cutting any wires to length. Begin by routing the power +12V wire from the battery to the amplifier location. Use a grommet when running wires through the firewall or metal openings. Avoid running the power wire near existing vehicle wiring to prevent induced noise from entering the audio system.
•Use extreme caution when drilling holes to avoid damaging fuel lines or existing vehicle wiring.
•The +12V wire MUST be fused within 18" of the battery for protection of the vehicle’s electrical system.
Ground Wire (GND)
•The amplifier ground wire should be as short as possible. Choose a clean unpainted section of metal or the vehicle chassis when attaching the ground connection. Be sure to clean the area of any dirt or grease.
Remote Turn-on Wire (REM)
•The remote
Input Signal
• The amplifier's input signal connects to the head unit's low level (RCA) outputs.
CAUTION
• Never run any wires underneath or outside the vehicle.
4