Atlantic Technology IWTS-30 SR, IWTS-14 SR Specifications, Painting the Speaker Assembly

Speaker Wiring 7

Instruction Manual
Installing the Speaker Assembly	Speaker Connection

The clamping mechanism allows the wall material to range from ½" to 1½" (13 to 38 mm) in thickness. There must be a minimum depth behind the wall face of 35⁄8” (92 mm).As noted above, be sure to keep the top and bot-

tom of the cutout at least 1½"

(38mm) away from obstruc-

tions, as the rotating clamps

will not operate properly if

you don’t.

Insert the speaker into the cutout and using a level or square carefully align it so it is level.Tighten the mounting

screws, which will cause the attached clamps to rotate and position them- selves properly behind the wall.

Continue to tighten until the speaker is snug in the wall.You want the bezel to conform to the wallboard,and the frame not to rattle from the speaker’s vibration, but be very careful not to overtighten the screws.

It is strongly recommended that you hand-tighten the mounting screws the final few turns (after using an electric screwdriver set to "low torque") to avoid the possibility of damaging the frame.

Painting the Speaker Assembly

The white plastic frame and the metal grille may be left as is, or painted to match your décor. To paint the frame, place the included Paint Shield over the drivers, then carefully spray paint with a plastic-compatible paint. To paint the grille, first remove it from the speaker, then spray using a slightly thinned paint or with two very light coats.

Strip about ½" (13 mm) of insulation from the connecting wires. Connect them to the appropriate push terminal, being careful to observe polarity (positive to the red terminal, negative to the black terminal).

Specifications

Model		IWTS-30 SR	IWTS-14 SR
THX Certification		THX Ultra	NA
Type		2-way Dipole/Bipole	2-way Dipole/Bipole
		Switchable	Switchable
Drivers	Woofer	(2) 5¼” (135mm) GLH§	(2) 4½” (115mm) GLH§
	Tweeter	(2) 1" (25mm) soft dome	(2) 1" (25mm) soft dome
Frequency Response		80Hz – 20kHz ±3dB	100Hz – 20kHz ±3dB
Nominal Impedance		6 Ohms	6 Ohms
Crossover Frequency		3500Hz	4000Hz
Sensitivity		87dB	87dB
Recommended		25 – 150 Watts RMS	25-125 Watts RMS
Amplifier Power
Overall Dimensions		155⁄8 x 121⁄8 x 3¾"	155⁄8 x 121⁄8 x 3¾"
(W x H x D)		397 x 308 x 96mm	397 x 308 x 96mm
Cutout Dimensions		14¼ x 10¾"	14¼ x 10¾"
(W x H)		362 x 273mm	362 x 273mm
Weight (ea)		9lbs; 4.1kg	8lbs; 3.7kg

§Graphite Loaded Homopolymer

Specifications are those in effect at the time of printing. Atlantic Technology reserves the right to change specifications or appearance at any time without notice.

THX, and THX Select are trademarks of THX Inc. Dolby Digital, 5.1, Dolby Stereo and Dolby Pro Logic are trademarks of Dolby Laboratories Licensing Corporation. DTS is a registered trade- mark of DTS Technology.