Roadmaster VRCD100M, RMCD100M manual Basic Operation, Sound Characteristics

Page 10

Basic Operation

1. Turning the Unit On / Off

Press the power button to turn the unit on, press the POWER button again to turn the unit off.

2. Mode Selection

Press the BAND Button to select Radio Mode.

Press the Play / Pause Button to when there is a CD in the unit to start playing the CD.

Press the AUX Button when there is an audio source plugged into the Auxiliary Input Jack.

Sound Characteristics

Use the SEL Button to access the units sound characteristics. Each time you press the SEL Button the unit advances to the next adjustable sound characteristic.

VOL BAS TRE BAL

1. Volume

Press the SEL Button until the display shows “VOL”. Use the VOL + / - Buttons to adjust the Volume level. The Volume levels are 0 - 63, the larger the VOL number, the higher the Volume level.

2. Bass

Press the SEL Button until the display shows “BAS”. Use the VOL + / - Buttons to adjust the Bass level. When DSP is ON, bass control is not available.

3. Treble

Press SEL Button until and the display shows “TRE”. Use the VOL + / - Buttons to adjust the Treble level. When DSP is ON, Treble control is not available.

4. Balance

Press SEL Button until the display shows “BAL”, then use the VOL +/- Buttons to adjust the volume balance between the left & right speakers.

5. Loudness Control

Press the LUD/RDM Button to emphasize the Bass output, the word “LOUD” on the display indicates that the loudness func- tion is on. Press again to cancel.

6. Mute

Press the MUTE Button to turn the volume off. Press this button again to turn the vol- ume on again.

7. Preset Equalizer Function

Press the EQ Button to choose the EQ mode between POP, CLASSIC, and ROCK. POP, CLS, or ROC will show on the display indicating which equalizer setting is in use.

8. Clock

The clock can be set anytime when the power is on. Press and hold the CLK but- ton, the time will blink on the display.

1.Press the << Button to adjust the hour.

2.Press the >> Button to adjust the minute.

3.Press the CLK Button again or leave the unit idle for new setting to effect. Press the CLK Button anytime to view the time clock display.

9

Image 10
Contents VRCD100M/RMCD100M Welcome Care of Discs PrecautionsThis unit will only play the following discs Page Mark Polarity of the Speaker Wires Remove the Old Unit from the DashboardInstallation DIN FRONT-MOUNT Method aDIN REAR-MOUNT Method B PartsWiring Connections Speaker Wiring NotesLocation of the Controls Sound Characteristics Basic OperationAuxiliary Input Radio OperationCD Operation RCA OutputSimple Troubleshooting Guide Problem CAUSE/SOLUTIONSpecifications GeneralLimited Warranty Conditions of Warranty