Installation
DIN REAR-MOUNT (Method B)
Installation using the screw holes on both sides of the unit.
1. Screw holes on the side of the unit.
2. Screws. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket.
3. Vehicle’s Factory Mounting Bracket
4. Dashboard or Console
5 Hook (Remove this part)
Note: The mounting sleeve, outer trim ring, and the mounting strap are not used for this method of installation.
| PARTS |
2 | Keys |
1 Hex Nut | |
2 Lock Washers | |
1 | Sheet Metal Screw |
1 | Metal Support Strap |
2 | Flat Washers |
1 | Mounting Bolt |
1 | Faceplate Case |
1 | Faceplate(not shown) |
| 6 |
VRCD220S English PROOF Manual.indd 7
10/15/08 11:34:14 AM