Basic Operation

1. Turning the Unit On / Off

Press any button to turn the unit on, WELCOME will be displayed on the LCD to indicate it is ready for use. Press and hold the POWER button to turn the unit off.

2. Mode Selection

Press the MODE Button to cycle between AUX, RADIO and CD modes.

3. Volume

Use the VOL +/- Buttons to adjust the vol- ume level. The higher the VOL number, the higher the volume level.

4. Bass

Press the “SEL” Button until the display shows “BAS”. Use the VOL +/- Buttons to adjust. When DSP is ON, the Bass control is not available.

5. Treble

Press “SEL” Button until the display shows “TRE”. Use the VOL +/- Buttons to adjust. When DSP is ON, the treble control is not available.

6. Balance

Press “SEL” Button until the display shows “BAL”, then use the VOL +/- Button to adjust the balance between the left & right speakers.

7. Fader

Press “SEL” Button five times and the display shows “FAD”, then use the VOL +/- Button to adjust the balance between the front & rear speakers.

8. Clock

1. While listening to the radio, press the
	“CLK” button until the clock is dis-
	played
2.	Press and hold the “CLK” button until
	the time starts to flash
3.	Press the VOL + Button to adjust the
	hour
4.	Press the VOL – button to adjust the
	minutes
5.	Press the “CLK” button again or just

9. DSP-Preset Equalizer Function

1.Press and hold the “SEL” button until you hear a beep.

2.Press the “SEL” button to cycle through the menu choices until you see DSP OFF. 3. Press the +/- buttons to cycle through the pre-set EQ settings.

DSP OFF POP M ROCK M

FLAT M CLASS M

4.Leave the unit idle for the new setting to take effect.

10. Loudness

1.Press and hold the “SEL” Button until you hear a beep.

2.Press the “SEL” Button until the display shows “LOUD OFF”.

3.Use the +/- Buttons to select “LOUD ON” (Loudness effect ON) or “LOUD OFF” (Loudness effect OFF).

4.Leave the unit idle for the new setting to take effect

11. Preset Beep Sound Off

1.Press and hold the “SEL” Button until you hear a beep.

2.Press the “SEL” Button until the display shows “BEEP ON”.

3.Use the +/- Buttons to select “BEEP ON” (beep sound on) or “BEEP OFF” (beep sound off).

4.Leave the unit idle for the new setting to take effect.

12. Preset Volume Level

You can set the default volume level for the unit when it is turned ON.

1. Press and hold the “SEL” Button until you hear a beep.

2. Press the “SEL” Button until the display shows “VOL LAST”.

3. Press the +/- Buttons to enter “VOL ADJ “ will be displayed.

4. Press the “SEL” Button and “A- VOL 15” will be displayed. The number after A- VOL indicates the volume level the unit will default to the next time you turn the

leave the the unit idle for a few new set-

tings to take effect.

unit ON.

VRCD220S English PROOF Manual.indd 10

10/15/08 11:34:18 AM