Insert end caps, Attach the mounting pipe to the foot

Make sure to place the leads of the matching transformer between the two washers on each post as shown here.

&INALLY TIGHTEN THE HEX NUTS TO SECURE THE LEADS

Step 6: Insert end caps

Insert the plastic end caps in the ends of the booms as shown here. Use a rubber mallet to gently tap them into the antenna booms to secure them.

Step 7: Attach the mounting pipe to the foot

21/2” screw

Hex nut on

5/8” bolt

&IND THE END OF THE MOUNTING PIPE WITH holes on the sides for screws. Insert this end into the middle of the foot as illustrated here. Then insert the 2-1/2” screw through the foot and pipe as shown. 3CREW THE v HEX NUT ONTO THE END OF THE screw to hold the pipe and foot together. Don’t tighten the nut completely yet.

&IND THE SQUARE HOLES ON EITHER SIDE OF the bottom of the pipe. Raise the pipe slightly and insert a 5/8” bolt through these holes and out of the side of the foot. Install the nuts on the outside of the foot on the 5/8” bolts to hold the pipe in place. Don’t tighten the nuts completely yet.