OPERATION
Remote Sensor
There is a remote sensor on the front panel. On the monitor, there is another remote sensor to receive remote control signal. You can point the remote control handset to the remote sensor on the front panel (when the monitor doesn’t stretch out) or the remote sensor on the monitor panel (when the monitor stretches out) and press function keys on the remote control to control the DVD unit.
The unit is also connected to an external remote receiver (See the electrical connection diagram), and the function is the same with the remote sensor on the front panel or on the monitor panel.
Notes:
∆The external remote receiver is placed near the monitor for the best reception of the remote signal.
∆If the angle of the monitor from vertical exceeds ± 30° (Especially the distance exceeds 3m.), controlling the DVD unit through the remote sensor on the front panel may not be effictive. You are suggested to use the external remote receiver.
6.5 Inch TFT Display
When the monitor stretches out, the 6.5 inch color TFT display can show the current state of the unit.
Volume Level Adjustment
Press VOL+/- buttons on the remote control to increase or decrease the volume level.
Mode Selection
Press MODE button on the remote control to select among DVD, RADIO,TV, AV and RGB mode.
Reset
Reset button is placed on the front panel and must be activated with either a ballpoint pen or thin metal object. The reset button is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Picture mode Adjustment
Press PICT button on the monitor panel, the picture mode will show on the display, repeatedly press PICT button to select among BRIGHT, CONTRAST, COLOR, TINT (For the unit with NTSC system) and SCREEN.
(For the unit with PAL system):
PICTURE
BRIGHT32
CONTRAST 32
COLOR32
SCREEN16:9
(For the unit with NTSC system):
PICTURE
BRIGHT32
CONTRAST 32
COLOR32
TINT32
SCREEN16:9
Press +/- buttons on the monitor panel to adjust the selected item. The corresponding value will show on the display.
NOTE (FOR THE UNIT WITH TEL- MUTE AND BRAKE FUNCTION)
•When there is an incoming call, the unit will be in mute state, and “TEL MUTE” appears on the screen display.
•If the brake wire isn’t connected to the ground (when driving, in BRAKE OFF), the picture will not be shown on the screen in DVD/TV/AV mode for safety purpose. Only the audio will be heard.
16