PYLE Audio PLTVRDIN65 Din Front/Rear-Mount, Installation Opening, Installing the unit

Page 6

INSTALLATION

Notes:

Choose the mounting location where the unit will not interfere with the normal driving function of the driver.

Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

If installation angle exceeds 30˚ from horizontal, the unit might not give its optimum performance.

30˚

Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.

DIN FRONT/REAR-MOUNT

DIN FRONT-MOUNT (Method A)

Installation Opening

This unit can be installed in any dashboard having an opening as shown below:

53 mm

182 mm

Installing the unit

Be sure you test all connections first, and then follow these steps to install the unit.

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Disconnect the wire harness and the antenna.

3.Lift the top of the outer trim ring then pull it out to remove it.

4.The two supplied keys release tabs inside the unit's sleeve so you can remove it. Insert the keys as far as they will go (with the notches facing up) into the appropriate slots at the middle left and right sides of the unit. Then slide the sleeve off the back of the unit.

Sleeve

L Key

Outer Trim Ring

R Key

This unit can be properly installed either from “Front” (conventional DIN Front- mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis).

For details, refer to the following illustrated installation methods.

5.Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend open the tabs located around the sleeve with a screwdriver. Not all tabs will be able to make contact, so examine which ones will be most effective. Bending open the appropriate tabs behind the dashboard to secure the sleeve in place.

6

Image 6
Contents PLTVRDIN65 Features Compatible with PAL DVD Video CD and Ntsc DVD Video CDUSE this Product Safely Contents Safety Information Region Management InformationDisc Notes DVDMP3 Installing the unit InstallationInstallation Opening DIN FRONT/REAR-MOUNTDIN FRONT-MOUNT Method B Removing the unitPlayer Front ViewClosed Position Open Position Back View Radio BOX ONE Side Another SideElectrical Connection DVD UnitRemote Control Location and Function of Keys36 2 6 10 9 Eject PowerSetup SubtitleLoading a Disc Preparing the Remote ControlLOADING/EJECTING a Disc Ejecting a DiscBasic Operation Open/Close the Monitor and Angle AdjustmentOperation Turnig the player on/offReset Volume Level AdjustmentMode Selection Picture mode AdjustmentDisc DVD, VCD, CD, MP3 Operation Zoom Disc Search GotoFor CD/VCD with PBC OFF ProgramOn-Screen Display Function VCDTitle Menu Function For DVD only Multi-audio Language FunctionMenu Function For DVD Only Multi-subtitle Language Function For DVD onlySmart navigation in MP3 Play Switching to radio modeSetting memory Radio OperationTV Operation AV Operation RGB OperationSetup Initial SetupGeneral Setup OSD Lang type setup PIC mode setupAngle Mark display setup Captions setupSCR Saver setup Audio SetupSpeaker Setup OP ModeAudio language setup Preferences SetupTV type setup Dynamic Range ControlPassword Subtitle language setupTV Type Audio Subtitle Disc Menu Parental Password Smart NAV Adult MainFull Defaults TableDefaults 3308Trouble Shooting Specifications GeneralRadio 88-V1953-08