PYLE Audio PLTVD7IN manual Preparing & Using The Remote Control, Battery Installation

Page 12

INTRODUCTION

4. BATTERY

Preparing & Using The Remote Control

BATTERY INSTALLATION

NOTICE (BATTERY)

PLEASE FOLLOW THE INSTRUCTIONS

BELOW. INCORRECT BATTERY USEAGE

MIGHT CAUSE EARLY DISCHARGE, LEAKAGE

OR CORROSION DAMAGE.

*Do not insert battery in the wrong direction. Be sure to observe the correct polarity (+/-) as indicated in the battery compartment.

*It is dangerous to charge/heat/open or short circuitry the battery.

*Please remove the battery in case of not using the remote control for a long period of time.

*It is time to replace the battery if the remote control does not work properly or if the operating range becomes reduced.

*Should battery leakage occur, clean the battery compartment with a soft cloth and replace with a new battery.

USING THE REMOTE CONTROL

NOTICE (REMOTE CONTROL)

The remote control should be pointed at the remote sensor in order for the Unit Monitor to function correctly.

Distance: Maximum of 16 feet from the front of the remote sensor.

Angle: Approximately ￿￿￿30 from center.

Please do not locate the Unit where direct sunlight or fluorescent illumination might shine directly at the remote sensor. This will interfere with proper remote control operation.

*The remote control should be aimed directly towards the remote sensor of the Unit.

*Avoid dropping the remote control.

*Avoid spilling liquids on the remote control or exposing it to extreme heat.

10

Image 12
Contents Page Page Safety precaution Contents Marking of products using lasers Except for some areas Lens FoggingCleaning the Faceplate terminals Cleaning the UnitCleaning the CD Slot Removing CDs CDs that can t be usedIntroduction Region NumberControl Parts With Display Closed Introduction With the Display ClosedWith the Display Opened Same as Track CH Up/DownPage Battery Preparing & Using The Remote ControlBattery Installation Using the Remote ControlRemote Control Key Connecting to Power System Head UnitRT BOX Multi Channel AV Control Unit System RT BOX 16P Connector Wiring Diagram Connecting to Multi Channel AV Control Unit System Connecting to DVD Changer Control System Connecting to Power & Multi Channel AV Control Unit System Basic Operation Audio Control PRE Adjust Color System PRE Adjust Adjust TV SystemPRE Adjust Adjust Radio System PRE Adjust Adjust Sound MIXFront -- Rear -- ALL -- OFF L+R -- OFFPRE Adjust Adjust Rear CCD- for Rear View Camera On -- OFFRear Monitor RDS Radio Data System Auto Tilt SystemTuning TV-AUTO Search Tuning RADIO-AUTO SearchOverview of the RDS Function PTY Program Type PTY Music group --- PTY Speech group --- PTY offChanging DVD System Setting DVD Video Player OperationBasic Playback PreparationLoading 8cm discs POWER/MODE How to use RemoconOPEN/CLOSE EjectChanging Subtitle Language S -TITLE Changing Audio Sound Track Language AudioDisplay Repeat SET UP B RepeatDirection Buttons MENU/TITLE Navigation & Movement After playback Last Memory Picking UP Where YOU Left OFF & Others Volume UP/ DownGoto Search ZoomAngle Slow DiscDVD Menu Preset SCAN/BSM AM/FM Radio OperationBand AM/FM Manual Seek UP/DOWNPreset SCAN/ BSM TV OperationManual UP/DOWN Fine TuneInstallation Installation Supplied Mounting KITSpecifications