Installation
Notes:
-Choose the mounting location where the unit will not interfere with the normal driving function of the driver.
-Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.
-Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
-Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
-Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
-If installation angel exceeds 30°from horizontal, the unit might not give its optimum performance
-Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
Din Front/Rear-Mount
This unit can be properly installed either from 'Front' (conventional DIN
Take Out Screw Before Installation
Before install the unit, please remove the two screws.
Take out screws before installation
1.DIN Front-Mount(Method A) Installing the unit
1
2
182
53
3
(Fig.1)
1.Dashboard
2.Hoder
After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and ben them inwards to secure the holder in place.
3.Screw
1
6
2
35
7
4
(Fig.2)
1.Dashboard
2.Nut (5mm)
3.Spring washer
4.Screw (5X25mm)
5.Screw
6.Strap
Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle.
7.Plain washer
Removing the unit
1
2
3
1