PYLE Audio PLCD21 instruction manual Tab, Installing the Front Panel

Page 4

1.Frame

2.Release Frame Key

Insert the release frame key into the groove at the right side of the frame, then prize out to remove the frame (You can also use the key to remove the frame from the left side.)

3.Release Unit Key

After releasing the frame, insert the

release unit keys supplied with the accessory into the grooves at both sides of the unit as shown in figure until they click. Pulling the keys makes it possible to remove the unit from the dashboard.

1. DIN Rear-Mount(Method B)

31

Using The Detachable Front Panel

Removing the front panel

1.Press the release REL button (1) on the front panel.

2. Pull off the front panel.

6

2

4

5

Tab

3. Keep front panel into the case.

1.Factory-installed radio bracket

2.Car radio mounting bracket

3.Screw

4.After aligning the car radio mounting bracket with the factory-installed radio bracket, tighten the screws (M5X4mm) at 2 places on each side.

5.When fixing factory-installed radio bracket with the screws, use a standard-tipped screwdriver to pry the tabs of the car radio mounting bracket to make them fit into holes in the factory-installed radio bracket.

6.Movable panel frame.

INSTALLING THE FRONT PANEL

To install the front panel, insert the panel into the housing and make sure the panel is properly installed. Otherwise, abnormality occurs on the display or some keys will not function properly.

2

Image 4
Contents Mobile Audio System Contents Installation Take Out Screw Before InstallationDIN Front-MountMethod a Installing the unit Din Front/Rear-MountInstalling the Front Panel TabPrecautions when handling Wiring DiagramOperation Switching ON/OFF the Unit Sound AdjustmentDISPLAYING/ADJUSTING Time Reset FunctionSwitching to CD Mode Tune ButtonLoading a Disc Removing a DiscDisc Cleaning Handling and CleaningPreparing New Discs with Rough Spots Specification GeneralCD Player RadioNo power Disc cannot be loaded or ejectedNo sound Sound skips