PYLE Audio PLD175TBT instruction manual DIN Rear-MountMethod B

1

2

182

53

3

(Fig.1)

1. Dashboard

2. Hoder

After inserting the holder into the

dashboard, select the appropriate tab

according to the thickness of the

dashboard material and ben them

inwards to secure the holder in place.

3. Screw

1.Frame

2.Release Frame Key

Insert the release frame key into the groove at the right side of the frame, then prize out to remove the frame (You can also use the key to remove the frame from the left side.)

3.Release Unit Key

After releasing the frame, insert the

release unit keys supplied with the accessory into the grooves at both sides of the unit as shown in figure until they click. Pulling the keys makes it possible to remove the unit from the dashboard.

2. DIN Rear-Mount(Method B)

31

1

6

2

35

7

4

(Fig.2)

1. Dashboard

2. Nut (5mm)

3. Spring washer

4. Screw (5X25mm)

5. Screw

6

2

4

5

Tab

6.	Strap
	Be sure to use the strap to secure the
	back of the unit in place. The strap can
	be bent by hand to the desired angle.
7.	Plain washer

Removing the unit

1

2

3

1.Factory-installed radio bracket

2.Car radio mounting bracket

3.Screw

4.After aligning the car radio mounting bracket with the factory-installed radio bracket, tighten the screws (M5X4mm) at 2 places on each side.

5.When fixing factory-installed radio bracket with the screws, use a standard-tipped screwdriver to pry the tabs of the car radio mounting bracket to make them fit into holes in the factory-installed radio bracket.

6.Movable panel frame.

3