PYLE Audio PLPK5TVD owner manual Din Rear-Mount

Page 4

1

6

4

2

7

35

(Fig. 2)

Removing the unit

1

1.Dashboard

2.Nut (M5)

3.Spring Washer

4.Tapping Screw with Washer (M5 x 25)

5.Screw

6.Plain Washer

7.Strap

Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle.

1.Lever

Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers upward and out to makes it possible to remove the unit.

DIN REAR-MOUNT

Installation using the screw holes on the both sides of the unit.

1

2

5

4

3

2

5

Fastening the unit to the factory radio mounting bracket.

1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side.

Use either truss screws (5 x 6mm) or screws (4 x 6mm), depending on the shape of the screw holes in the bracket.

2.Screw

3.Factory Radio Mounting Bracket

4.Dashboard or Console

5.Hook and Screw (Remove this part)

Note: The frame, strap, and half-sleeve are not used for REAR-MOUNT.

4

Image 4
Contents PLPK5TVD Installation Installation HardwareMounting the Tuner Unit Install the Display UnitDIN FRONT-MOUNT DIN REAR-MOUNT HOW to Open and Close the Screen Display Page Electrical Connection RADIO/TV Main Unit View from FrontOperation General Operation Reset Time SettingLiquid Crystal Display Radio Operation Selecting BandSelecting Station Selecting MemoryTV Operation Picture MenuPosition setup Skip setupTuner Menu Tuner MenuFine setup Band setupAFT Auto Frequency Trace setup Search setup ASM Auto Search Memory setupSystem Menu System MenuColor setup Sound setupLANG. Language setup Blue Background setupCoring setup Halftone setupScreen Display Program ScanningRemote Sensor Remote Control Handset Control & Function KeysGeneral SpecificationRadio