1. Dashboard
1
6
7
4
2. | Nut (5mm) |
3. | Spring washer |
4. | Screw (5 x 25mm) |
23
5
5. | Screw |
6. | Strap |
| Be sure to use the strap to secure the |
| back of the unit in place. The strap can |
(Fig. 2)
Removing the unit
1
2
3
be bent by hand to the desired angle. |
7. Plain washer |
1.Frame
2.Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.)
3.Lever
Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard.
DIN REAR-MOUNT (Method B)
Installation using the screw holes on the sides of the unit.
1
2
4
5
3
2
5
Fastening the unit to the factory radio mounting bracket.
1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side.
Use either truss screws (5 x 5mm) or flush surface screws (4 x 5mm), depending on the shape of the screw holes in the bracket.
2.Screw
3.Factory radio mounting bracket
4.Dashboard or Console
5.Hook (Remove this part)
Note: The mounting box, outer trim ring, and
3