•SOUND ADJUSTMENT
Press SEL button (10) to select the desired adjustment mode. The adjustment mode will change in the following order:
Volume 
Bass 
Treble 
Balance 
Fader 
By pressing VOL button (11) or VOL button (12), it is possible to adjust the desired sound quality.
•LOUDNESS
Press BND/LOU button (13) for several seconds to reinforce the bass output and display will show “LOUD”. Press it for several seconds again to release this function.
•SET THE CLOCK
Holding down the DSP button (15) until the clock is shown on the LCD display and
flashed. Then press the TUNE/SEEK/TRACK | button (17) to change hours or | |
TUNE/SEEK/TRACK | button (16) to change minutes. | |
•SELECT MODE
Press MOD button (6) to choose desired listening mode. (e.g. radio mode to CD mode)
•MUTE
Press MUT button (3) to silence the receiver. Press it again to resume listening.
•LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display (8).
•EQUALIZATION
Press EQ button (19) to turn on equalization function and to select desired audio mode. There are five kinds of mode as below:
FLAT 
CLASSICS 
POP M 
ROCK M 
DSP OFF 
•FLASHING LED
If the front panel does not install in the unit, the LED (24) will be flashing.
•RESET
RESET button (25) must be activated with either a ball point pen or thin metal object. RESET button (25) is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Note: If press RESET button (25), the unit can’t work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the front panel.
7