Amplifier Owner’s Manual
RX600.5
5 CHANNEL POWER AMPLIFIER
FRONT, REAR AND SUB INPUTS
Connect preamp signal cables from headunit to these inputs. The front, rear and sub inputs must be used. For example, if only the front input is used then the rear and subwoofer speaker outputs will have no output signal.
SENS
Used to reach maximum amplifier power with a wide variety of headunits.
BASS BOOST
Variable bass boost from 0 to +18dB @ 45Hz.
HPF/LPF CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs.
REMOTE BASS LEVEL CONTROL (RBC)
This port is for connecting the remote subwoofer level control. This allows up to 20dB of volume adjustment for the subwoofer channel. This is not a bass boost, it controls the level of the low pass signal.
NOTE: This control is not compatible with the Phoenix Gold LPL44 level control.
+12V
This must be connected to the fused positive terminal (+12V) of the car’s battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to switched +12V, usually a trigger wire coming from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car’s battery or bolted to a clean, unpainted part of the chassis of the vehicle.
REMOTE MONITORING DISPLAY (RMD)
Connect optional RMD Voltage Display to this port.
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. RX600.5’s minimum impedance is 4 ohms bridged or 2 ohms stereo on front and rear channels. Use the Right + and Left - to bridge the channels. Minimum impedance is 2 ohms for the subwoofer channel and its not bridgeable.
Phoenix Gold • www.phoenixgold.com