Phoenix Gold SD1100.5 FRONT, Rear and SUB Inputs, SUB Input Switch, HPF/LPF Crossover Frequency

Page 5

Amplifier Owner’s Manual

SD1100.5

5 CHANNEL POWER AMPLIFIER

FRONT, REAR AND SUB INPUTS

Connect preamp signal cables from headunit to these inputs.

SUB INPUT SWITCH

Determines which input will feed signal to the subwoofer channel. “IN” or SUB = Use the Sub Input

“OUT” or F/R = Use the Front and Rear inputs as its signal will be summed then sent to the sub channel of the amplifier.

HPF/LPF CROSSOVER FREQUENCY

Controls the crossover point for the speaker outputs.

SENS

Used to reach maximum amplifier power with a wide variety of headunits.

BASS BOOST

Variable bass boost from 0 to +18dB @ 45Hz.

REMOTE BASS LEVEL CONTROL (RBCF)

This port is for connecting the remote subwoofer level control. This allows up to 20dB of volume adjustment for the subwoofer channel. This is not a bass boost, it controls the level of the low pass signal.

NOTE: This control is not compatible with the Phoenix Gold LPL44 level control.

+12V

This must be connected to the fused positive terminal (+12V) of the car’s battery. The fuse must be located within 18 inches of the battery.

REMOTE

This must be connected to switched +12V, usually a trigger wire coming from the head unit or ignition.

GROUND

This must be connected to the negative terminal of the car’s battery or bolted to a clean, unpainted part of the chassis of the vehicle.

REMOTE MONITORING DISPLAY (RMD)

Connect optional RMD Voltage Display to this port.

SPEAKER OUTPUTS

Used to connect the amplifier to speakers. SD1100.5’s minimum impedance is 4 ohms bridged or 2 ohms stereo on front and rear channels. Use the Left + and Right - to bridge the channels. Minimum impedance is 2 ohms for the subwoofer channel and its not bridgeable.

www.phoenixgold.com

Image 5
Contents Amplifier Manual Manual DEL Amplificador Model SD800.4, SD1100.5SD800.4 Specifications SpecificationsKEY Features Channel Power Amplifier FRONT, Rear and SUB Inputs SUB Input SwitchHPF/LPF Crossover Frequency Remote Bass Level Control RbcfFrequent Amplifier Shutdown with Automatic Recovery System TuningTroubleshooting Amplificador DE Potencia DE 4 Canales ConfiguracionRemoto TierraEntradas Amplificador DE Potencia DE 5 CanalesHPF/LPF Frecuencia de Crossover SUB Seleccion DE EntradeCorrección DE Problemas Installation Notes Sistema TuningEntrée Borne TélécommandeNiveau PASSE-HAUTSélection D’ENTRÉE SUB Commande À Distance DU Niveau DES BassesEntrée DE L’AFFICHAGE DE Tension a Distance RMD Limited Warranty on Amplifiers