Programming the SWI-JACK to Control the Head Unit
IMPORTANT! Some steps of the programming instructions must be completed within a certain number of seconds following the previous step. Review the complete instruction before beginning the programming sequence.
Step 11.
Turn the vehicle ignition to the ON position.
IGN
ACC
STRT
OFF
SWI-JACK
LED will flash to indicate set version number.
If you programmed the interface for version #4, proceed with the following steps.
If you did not program the interface for version #4, skip to Step 18.
Step 12. |
| SWI- |
|
|
Press and hold | JACK | LED will light. | ||
programming/ |
|
| ||
mode button |
|
|
|
|
on |
|
|
|
|
Step 13.
Release programming/ mode button.
Step 14. |
| |
Press and hold the TEMP UP | TEMP | |
button on the steering wheel | ||
| ||
control. |
| |
Step 15. | TEMP | |
Release the TEMP UP button. | ||
|
SWI- | LED will turn off. |
JACK |
SWI- | JACK | LED will turn on. The |
| ||
| function is pro- | |
|
| grammed. |
Step 16.
Repeat Steps 14 and 15, using the TEMP DOWN Button.
Step 17a.
If the vehicle is equipped with FAN UP and FAN DOWN buttons:
Repeat Steps 14 and 15 for these buttons as well.
Step 17b.
If the vehicle is NOT equipped with FAN UP and FAN DOWN buttons:
SWI- | Press and release the programming/ |
JACK | mode button on the |
|
SWI-JACK
SWI-JACKIn either case, the LED will flash once and stay on.
Skip to Step 20. You have 7 sec- onds to perform 
the next step.
Step 18.
Press and hold program- ming/mode button on
SWI-JACK
SWI-JACK
LED will light.
Step 19.
Release programming/ mode button.
You only need to press the programming/mode button once to program all the buttons. If you press this button again after the interface is programmed, it will erase all previous learned buttons.