Orion 2002 manual Step By Step Installation

Page 14

Pliers (standard and needle nose)

Reference CD with 1 kHz Sine Wave at 0dB level (all bits high)

RTA (real time analyzer)

Soldering iron and solder

Utility knife

Wire brush or sandpaper for chassis grounding

Wire crimper

Wire cutters

Wire strippers

Step By Step Installation

Step 1 Determine the location for the amplifier. Refer to the Choosing Mounting Locations section of this guide for detailed information.

Step 2 Decide on the system configuration for your amplifier. For system sugges- tions, refer to the Speaker Connections section of this guide.

Step 3 Run all the wires from the amplifier location to the speakers, source unit, and battery. Do not connect the battery at this time. Be sure to run RCAs and power and speaker wires away from factory electrical wires and system as they pose a great potential for induced system noise.

Step 4 Pre-drill amplifier mounting holes. Be sure to "think before you drill". Gas tanks, fuel lines, and other obstructions have a nasty way of hiding them- selves. For best results use a marking pen to mark the mounting holes and pre-drill these holes with a standard 1/8" drill bit.

Step 5 Mount the amplifier. Make sure the amplifier is mounted on a flat surface. If this is not possible, do not over tighten the screws so that the chassis of the amplifier is twisted or bent.

Step 6 Turn the vehicle's key switch to the off position.

Step 7 Disconnect the vehicle's battery ground terminal.

Step 8 Connect the RCA and speaker wires to the amplifier. Check the quality of your speakers and signal connections. This will determine the ultimate per- formance of your Orion amplifier. Refer to the Signal Input and Output Level Controls and Speaker Connections sections of this manual for correct wiring instructions.

Step 9 Connect power wires to the amplifier. At this time do not connect the fuse at the main battery.

Step 10 Reconnect the ground terminal to the battery.

Step 11 Set crossovers. Refer to the Internal Crossover Configuration section of this manual for detailed instructions.

Step 12 Once satisfied that all connections and settings are correct, install the fuse located near the vehicle's battery and proceed to the Testing the System sec- tion of this manual.

WARNING! Never exceed the recommended fuse size of this amplifier. Failure to do so will result in voiding of your warranty and possible damage to the amplifier.

©2004 Directed Electronics, Inc.

13

Image 14
Contents Page Contents What’s in the Box IntroductionPractice Safe Sound Limited TWO-YEAR Consumer Warranty Record Your Serial Number and DateSpecifications Amplifier Section OrionDirected Electronics, Inc Amplifier Controls and Connections Internal Crossover Configuration Amplifier SettingsStereo / Mono Input Configuration Low-Pass CrossoverINTELLi Bass Control High-Pass CrossoverInput Gain Speaker Connections Amplifier WiringPower Connections Summed Bridged Configuration Passenger Compartment Amplifier InstallationChoosing Mounting Locations Trunk CompartmentGeneral Precautions and Installation Tips Tools of the TradeStep By Step Installation Adjusting the Sound of the System SET UP and TroubleshootingTesting the System Directed Electronics, Inc Troubleshooting Tips Symptom Probable Cause Action To TakeInternal Crossover Configuration Warranty