Profile 100SX installation instructions TWO Channel Speaker Connections

Page 10

SPEAKER CONNECTIONS

Make the speaker connections using speaker wire that is at least 16 gauge or heavier.

As with any audio component, proper phasing of the amplifier and speakers is essential for strong bass response. When connecting, make sure that positive (+) from the amplifier is connected to the positive (+) of the speaker, and the same for negative (-).

B + REM GND

L +

L - R + R -

FUSE

BRIDGED

4 Ohm Speakers (2 Ohm Minimum)

+-

+-

TWO CHANNEL SPEAKER CONNECTIONS

CH1, 2

CH3, 4

FUSE

L +

L - R + R - L +

L - R + R -

B + REM GND

BR ED

BR ED

+-

+-

+-

+-

Front Left	Front Right	Rear Left	Rear Right
4 Ohm Speakers		4 Ohm Speakers
(2 Ohm Minimum)		(2 Ohm Minimum)

FOUR CHANNEL SPEAKER CONNECTIONS

9

Image 10

Contents Mosfet Power Amplifiers Keep Your Sales Receipt IntroductionRecommendation Safety Precautions Features and Benefits Stable To 2 Ohm Stereo Mode Power FusingAdjustable Input Sensitivity Bass BoostMounting Location Power Connections Connect the amplifier to the cars batterySignal Connections TWO Channel Signal ConnectionsHigh Level Connections Optional Speaker Connections TWO Channel Speaker ConnectionsSpeaker Connections Bridged Speaker Connections TRI-MODE 100 FSelect your crossover type and frequency Setting the Crossover and Bass BoostFine Tune the System Fine tune the amplifiers input sensitivityTrouble Shooting the System Look for SolutionSpecifications 100SX600SX 440SX Limited Warranty Warranty Repair Policy Profile Consumer ELECTRONICS, INC Shoemaker AVE