Polk Audio PSW1200 instruction manual Dolby Digital / DTS

FIGURE 3.	DOLBY DIGITAL / DTS
	RECEIVER OR PROCESSOR

			FRONT	REAR	CENTER	LFE
			L
Bass Management/			R
Speaker Setup
Front: Large
Center: Large
Surround: Large
Subwoofer: Yes
	FRONT SPEAKER LEVEL OUT
	L	R
VARIABLE
LOW PASS
CROSSOVER		+
40Hz	120Hz
VARIABLE		–
PHASE
ALIGNMENT
0°	180°
	40HZ	SWITCHABLE
POWER
	80HZ	HIGH PASS
		CROSSOVER
AUTO OFF ON
		(SPEAKER LEVEL)
SWITCHABLE	FULL RANGE
HIGH PASS
CROSSOVER
(LINE LEVEL) 40HZ	80HZ
		+
FRONT	FRONT
LEFT	RIGHT
OUT	OUT
		–
LEFT	RIGHT
FRONT	FRONT
IN	IN
LEFT	RIGHT
REAR	REAR
IN	IN
CENTER 1	CENTER 2
IN	IN
LFE/SUBWOOFER IN

to the Subwoofer output jack, the Center bass would not go to the Subwoofer. In this case, you can select your Center as “Large” and hook up the center channel output directly to the Center channel input of the PSW1200.

(Fig. 2, previous page)

Now you have it all!

In fact, the PSW1200 has enough inputs to accept every channel of a 5.1 sur- round system. If you want to make sure

you get the bass from every channel through your Subwoofer, simply plug in the preamp output from each channel directly into the PSW1200. No guess- work and no lost bass information.

(Fig. 3)

The Front, Rear, and Center, etc., labels on the PSW1200’s inputs and outputs are just there for convenience. There is no reason why you cannot use a given set of jacks for another channel. For example, assume you want to roll off the

8