Polk Audio instruction manual PSW1200 Input and Output Features and USE

FIGURE 4.

							+
							–
					FRONT SPEAKER LEVEL OUT
					L		R
VARIABLE
LOW PASS
CROSSOVER						+
40Hz				120Hz
VARIABLE						–
PHASE
ALIGNMENT
0°				180°
						40HZ	SWITCHABLE
POWER
						80HZ	HIGH PASS
							CROSSOVER
AUTO		OFF		ON
						FULL RANGE	(SPEAKER LEVEL)
SWITCHABLE
HIGH PASS
CROSSOVER
(LINE LEVEL)	40HZ		80HZ
						–
FRONT				FRONT
LEFT				RIGHT
OUT				OUT
						+
LEFT				RIGHT
FRONT				FRONT
IN				IN
					L		R
LEFT				RIGHT	FRONT SPEAKER LEVEL IN
REAR				REAR
IN				IN
CENTER 1				CENTER 2
IN				IN
							80 HZ	40 HZ
LFE/SUBWOOFER IN

bottom end of the Rear speakers at 40Hz. Simply use either the Front Line Level or Front Speaker Level in/out sets to do that (assuming they are not already in use). Be creative.

PSW1200 INPUT AND OUTPUT FEATURES AND USE

Front Speaker Level In–Although these are labeled “Front,” they can be used for any channel. If your equipment does

FULL RANGE

not have—or if you do not wish to use— preamp level outputs to drive your Subwoofer, you can deliver signal via speaker wire (Fig. 4). The signal will pass through the Variable Low Pass Crossover.

FRONT SPEAKER LEVEL OUT–

These may be used to route signal to speakers, especially if you want the PSW1200 to filter bass frequencies out of those speakers. (Fig. 4)

9