Niles Audio cm5at manual CM8AT

Page 20

Specifications

Specifications

CM8AT

Driver Compliment

8" carbon/glass fiber with butyl rubber surround

1" fluid-cooled ultra-wide dispersion tri-laminate Teteron tweeter in a custom pivoting coaxial enclosure

Recommended Amplifier Power

10 to 150 watts per channel

Nominal Impedance

4 or 8 ohm selectable

Frequency Response

40Hz to 21kHz, +/- 3dB (on axis)

Tweeter Adjustment

Up to 20° pivot angle

Sensitivity

90dB for 2.83 volts of Pink Noise

Overall Exterior Frame Dimensions

10-5/8" diameter

Depth Behind Wall

4" deep (based on /2" drywall)

Wall Cut-Out Dimensions

9-1/2" diameter

Wiring Requirements

We recommend 16 to 18 gauge stranded wire for up to 80 feet, 14 gauge stranded wire for up to two hundred feet.

Connectors accommodate 12 to 18 gauge stranded wire.

19

Image 20

Contents CM5AT Table of Contents Introduction Features and Benefits Easy InstallationOr 8 ohm Selectable Impedance MicroPerf GrillesIncorporating a Local Volume Control Installation ConsiderationsRecommended Amplifier Power Installation Considerations Speaker WireIncorporating Remote Control Insulation Behind The SpeakerIntroduction Speaker PlacementPlacement for Critical Listening Placement for Varying Listening Positions Placement for Home Theater Rear ApplicationsVarying Listening Position Surround Sound Boundary Effect Installation FundamentalsRunning the Speaker Wire in New Construction Concealing Speaker Wire Existing Walls DrillingSpeaker Location Volume Control Stereo Installation Fundamentals Installation in New Construction ConstructionInsulating the Wall Cavity Mounting The New Construction BracketInstallation in Existing Construction See FigureFinal Installation in New or Existing Construction Final Installation in New or Existing ConstructionSpeaker Phase Painting the SpeakersListening at Higher Volumes CleaningOperation OperationsSpecifications SpecificationsCM8AT Warranty Registration Card Detach Here Limited Warranty Limited WarrantyNiles Audio Corporation