Features, Controls and Connectors | MMATS Professional Audio D600.2

SUGGESTED HOOKUP

	D600.2
	SPEAKER
	OUTPUTS
+ -	+ -

+ -	+ -
4 OHM	4 OHM

HOOKUP INTO TWO 4 OHM WOOFERS

	D600.2
	SPEAKER
	OUTPUTS
+ -	+ -

4 OHM 4 OHM +-

HOOKUP INTO ONE DUAL VOICE COIL

(4 OHMS PER COIL) WOOFER

FEATURES

Ultra- Efficient Class D Audio Output Stage

Regulated Pulse-Width-Modulated Power Supply

High Capacity Heat Sink

Adjustable 12db Low Pass Filter

Adjustable 45Hz Bass Boost

Low Level and Speaker Level Inputs

1% Surface Mount Components

Computer Optimized Transformer

Large Geometry Power MOSFETs

Overload and Thermal Protection

CONTROLS AND CONNECTORS

1.Positive Power Terminal - This is the power feed from the positive (+) terminal of the car’s battery. Use 8 gauge cable and good quality terminals when routing this connection. Tighten the connections well to prevent power loss due bad contact. Route the power cable away from the RCA and speaker cables

2.Fuses - Replace these fuses with only with the same type and value. These fuses only protect the amplifier. An additional inline fuse should be added at the battery to protect against a short in the main power cable to the amplifier.

3.Ground Terminal - For optimum performance, an 8 gauge cable and good quality connectors should attach the this terminal to the battery’s negative (-) terminal.

4.Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12 volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.