MAZDA RX-7 1986-91
MAZDA 626 / MX6 1986-92
(models equipped with factory receiver/pocket)
1
2
"A"
"A"
"A"
"A"
"A"
"A"
1 |
|
|
| 2 |
|
"E"
"E"
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (2) screws exposed in the ashtray cavity. Unsnap the gear shifter trim and remove (2) screws exposed. Unsnap the climate control trim bezel and remove (2) screws exposed. Remove the dash trim bezel and disconnect the wiring. Remove
(4)screws securing the factory head unit and disconnect the wiring.
Cut and remove all mounting tabs on Radio Housing #1 EXCEPT tabs "A". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (2) screws exposed. Remove the pocket and (2) screws exposed. Remove the radio trim bezel and disconnect the wiring. Remove (4) screws securing the factory dummy plate to the back of the bezel and discard the plate.
Cut and remove all mounting tabs on Radio Housing #2 EXCEPT tabs "E". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
MAZDA 626 / MX6
(models equipped with factory receiver/tape deck/eq/pocket)
ALL VEHICLES
3a
Fig. A
Fig. B
1 |
|
| 2 | "B" |
"B"
"B"
"B"
"B"
"B"
"B"
"B"
2-SHAFT HEAD UNITS: For models using Radio Housing #1, attach the Faceplate to the Housing. Slide the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A). For models using Radio Housing #2, slide the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. B)
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (2) screws exposed. Remove the pocket and (2) screws exposed. Remove the radio trim bezel and disconnect the wiring. Remove (4) screws securing the factory dummy plate to the back of the bezel and discard the plate.
Cut and remove all mounting tabs on Radio Housing #1 EXCEPT tabs "B". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
5 | 2 |